extending from a cistern isolation valve

[Kerry Davey]

hi, im a noviced and im trying to swap my toilet cistern for a new one but the water feed is on the wrong side.

i need to create an elbow from the isolation valve, which used to screw into the old ball cock, then 400mm 22mm pipe into another elbow into the a threaded ball cock.


which elbows would work??

please help

 

[Dotty]

22mm cold feed???

Yorkshire if you're confident with your soldering. Compression if you're not.

And push fit if you want it to look dog rough!

Make sure you clean any and all paint off before you joint.

And clip the pipe where you can or you may get hammer.

 

[Gray0689]

hi, im a noviced and im trying to swap my toilet cistern for a new one but the water feed is on the wrong side.

i need to create an elbow from the isolation valve, which used to screw into the old ball cock, then 400mm 22mm pipe into another elbow into the a threaded ball cock.


which elbows would work??

please help

Sounds like a service valve your on about
22mm are you looking at an overflow?