Pull the fridge freezer out and see if its wet in the bottom of the back of it. Are the seals ok on the doors and the drain hole in the fridge compartment clear?
If you ram the fridge full of shopping then it can cause excess moisture in the fridge which will need to escape somewhere.
You...
I have to replace pipework to a few rads as the 10mm is buried in the plaster which I dont want to have skimmed over and then wait for it to pin hole. Also they are fed up through the eaves too so i dont fancy waiting for them to freeze.
I wanted to replace the 10mm where i could in 15mm by...
Might be worth a look on ebay, the bids on this one were only £5.97 when I posted this.
Look at this on eBay Honeywell CM907 Digital Combi Boiler Room Thermostat / Programmer | eBay
I had the same problem with my wireless version screen. Mine was under 2yrs old though so Honeywell sent me a...
I was wondering if i would need to get into balancing.:(
Thanks for the quick reply. Maybe a rethink then although i will still need to get out and replace the 10mm from the plaster before it pin holes and leaks.
Hi all.
I just wanted to know what effect, if any, it will have on my combi heating system replacing some of the 10mm pipes to my rads with 15mm?
Its a bungalow and the boiler is piped up to span most of the loft in 22mm. This is then stepped to 15mm and then to 10mm for the drops down to the...
Well done Chris, its always satisfying when you do a job for the first time and it all goes well.
I replaced two in four years in the last house so at least you will have have the confidence now to tackle it next time it splits.
Cheers
Have you only tightened it finger tight then with you saying you cant get tools in there? They always leak if not tightened enough.
Could you get to it with one of these?
Adjustable Basin Wrench
Personally i would remove the cistern, tighten the inlet and then replace. Or, cut the copper...
Rather than mess about cant you take the inlet back and swap for one that isnt defective?
Ive found they always leak if only hand tight so i always nip them up with a spanner or grips. The plastic back nuts can strip their threads easily though if you over tighten.
I replace them fairly...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.