Moen Posi Temp1222A cartridge replacement. I replaced my old cartridge with a new one. I one with the handle goes from cold to hot. Now it goes from warm to hot. I reversed the cartridge and get warm to cold. I don’r what else to do so it can get cold to hot again. I tried at least 2 brand new...
Hi, we moved into a new house a while back and the main toilet has a large cistern and no dual flush capability. It gets used most of the time rather than the single ensuite we have so I was wondering if someone can recommend a kit to replace the lever with a two button arrangement or other...
Hi,
In my 2 bedroom flat I have a Worcester Greenstar 24i boiler and a 200 litre Zip AquaFlow hot water cylinder.
The hot water cylinder has started to slowly leak from the bottom and I think it will need completely replaced - quote to replace is around £1000.
Given that this is only a 2...
This radiator pipe got stepped on and now has a kink, if you can see in the pics. Should I get it cut back and a new bit soldered on or will it be alright as is? It's not leaking but presume it's going to restrict the flow, does that matter..? It's the pipe with the return valve it's not the...
Might be a very silly question, but have an old cistern toilet. Connects to the pipes as follows(see pic) - want to know if I can do a like for like replacement with any toilet type, or I'm limited for options.
Reason for changing is that toilet is getting blocked every 2-3 months - no issues...
Hope this is in the right forum.
We've a utility room radiator with 10mm pipework; fitted about 6 years ago it has a BOSS TRV which has failed (the sensor plunger just flops around - as if the sensor has leaked) and the radiator is always "on".
I don't consider 6 years a reasonable life so I'm...
Hi there!
First post here, I'm not a plumber.
So glad i find this video....
I have the same eco mag filter, and it was all boxed in....only discovered yesterday that the old boiler cupboard which is now my wardrobe is full of black mold! So been cleaning that all out yesterday :-( My eco...
I've been told to stick with the same power as it's simple to replace but I struggle to find 7.2kw showers and I was wondering if a 7.5kw shower has the same cables?
Hello
I wondered if anyone could advise me which cables go where, on the Heat Link for the Nest E Thermostat I have purchased.
The two cables shown are from behind the ATAG One Controller.
Thanks in advance
Back in the eons of time, we used to have a massive gas boiler (feeding the house via about 2 inch steel pipes). This was fed by a large commercial meter (G16 ?). About 15 years ago, we replaced the boiler with 3 x 30kW Combination boilers and split the supply in to two G4 meters.
The reason...
Hi there.
I installed this concealed 4 way shower diverter and thermostatic valve in the early 2000s. I think it was an Ultra Helix from memory. The diverter (top) is leaking and needs replacing (or just the ceramic and seals).
I cant for the life if me remember how I get the face plate off...
Hello. I have a two-zone heating set up, with each zone controlled by a 2-port zone valve (Honeywell V4043H by the looks of it), and each zone has a two-wire HoneywellCM707.
I would like to replace the CM707 in the master bedroom (for a mechanical stat that doesn;t click). In terms of...
I have a bathroom sink with an old Bristan depressable plug, see picture.
The depresser thingey has broken and I have removed the plug.
Is it easy to replace these things with other plugs that slot into the waste pipe? I dont want to have to remove the waste pipe, just put in a new plug.
Are...
My mother has a 40 year old heating and hot water system. Tanks in the loft. 7 year old heat only Worcester boiler.
In a large airing cupboard is the imaged setup (strange to me) pump and myson controller. I can plainly see the controller diverts hot water to the tank.
Each time BG service the...
Hi there.
First Post. I am having a problem with the pump pressure adjust electrical black box attached to the side of my Wilo Gold 50 pump. In the last few month's it has been necessary for me to use a screwdriver to move the white speed controller on top of this box in order to get the pump...
Replace the current E7 Newlec Economy control to a mechanical 24 hour timer switch for unvented cylinder water heater, may I know if I ask plumber or electrician to do this job.
Because Newlec Economy controller can heat up water once a day in midnight .I would require constant hot water in...
Hello,
I have a bathroom mixer tap which drips. I cannot see how to remove the valves as it is all smooth chrome. Would someone know how & what tool i would need please to take it apart ? I can send a photo if required.
Thank you and Happy New year....
Nik Warren
Thread
america
bathroom
dripping tap
mixer
mixer tap
replace
tap
tap cover
usa
Hi we had a Thermostatic Aqualisa shower valve upstairs that was tank fed upstairs in our house and it had great water pressure. We recently had our shower completely redone and the valve the plumber put in doesn't seem to be very good and the water now has very low pressure. We know the...
Alicia
Thread
again
america
pressure
reduced
replacereplacement
shower
shower valve
usa
valve
water
water pressure
Hi All,
Last night i discovered my Worcester 35CDi II was leaking, I had a new expansion vessel fitted in may as the old one had failed along with a new PRV.
I think it is probably about time to replace the boiler given it was installed when the house was built in 2002 so is approaching 20...
Anybody bought an anton pro2 to replace a v2. The gas sniffer has a different connection. Can you get an adaptor to make fit or is it another £70 to anton?
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.