Hi all,
I have a Heatmiser UFH installation, 7-8 years old now. This week we noticed that a few of our heating zones were not warming up, even though the thermostat was showing the flame symbol. They were working fine last winter. I knew from when I looked at the installation in the past that...
https://victoriaplum.com/browse/all-showers/type_Exposed-mixer-showers?csi=SHS30&ds_kid=92700067325954114&gclid=CjwKCAiA8OmdBhAgEiwAShr407d2c-jzpnzzY-36CoW00ayMz-g6iHjgD2mPTxyhm5U7HSwbT8bYCBoCt2QQAvD_BwE&gclsrc=aw.ds#&gid=1&pid=1
I have the above shower/bath thermostatic mixer shower/tap. Have...
Can anyone advise if a Watchman Sonic oil tank monitor can fit the hole used for an old Sensor Systems Niveau Watchman? I want to replace the old hardware and the new Watchman Sonic needs a 32mm hole. Obviously I'd rather not have to drill a new hole. I don't have access to the tank at the...
Hi,
I live in a bungalow and I am refitting my kitchen/diner.
The existing radiator needs to be moved to the other end of the kitchen and replaced with a vertical radiator which I have just bought.
I can do some DIY plumbing myself, but need some advice.
I could reroute the pipes from the...
I would like to replace my ancient Honeywell mechanical thermostat with a Honeywell T3R PROGRAMMABLE THERMOSTAT
I have three wires in the old thermostat. Please see the first three photos.
1 Red
3 Yellow
2 Blue
are these
1 Live
3 Live return (Switched)
2 Neutral
Could I configure it as in...
Hi
Is it possible for a DIYer to replace an expansion vessel and hose? It's an external grant vortex boiler and from what I've seen online it looks simple enough
Hi All,
I have a 2m x 2m bathroom suite which I'd like to completely change out myself. I'd be replacing the bathroom suite for like for like. I'm going to go for something like the following...
So I've got a Glow Worm back boiler fronted by a gas fire, at least 15 years old probably a lot more.
The water heating makes a row as there is a partial blockage in one of the pipes - this I believe to be resolvable with a power flush and pump replacement.
The front fire is spilling fumes and...
My kitchen radiator is filling with hot water despite my TRV being set to 0. It's blazing at maximum.
This goes for the rad when I try two separate TRVs I have tried, which happen to be...
Basic programmable Bluetooth one that uses a motorised push-pin.
Old basic TRV with settings 0-5.
On...
What parts do I need to replace this 40mm setup? I'm thinking of cutting the pipe to the right and replace the rotten part with a flexible connection. The T goes into a ceramic drain pipe.
I'm sure this is an old question but here goes. I'm looking for some advice regarding switching from a conventional boiler to a combi.
I moved into my current house about a year ago. It has a conventional boiler with a hot water tank. The boiler is Vitodens 100-W, which is a condenser boiler...
Hello we currently have an old Stanley range cooker in the kitchen and a back burner in the living room. There is also a hot water tank in the bathroom.
The plan is to remove the cooker and plumb in a regular external oil boiler.
Would it be fine to use the existing flow and return from the...
Morning All
After some advise on repairing a sink waste that goes into the toilet pan, which goes straight into soil stack.
Had bathroom done 2 years ago, and then needed a new basin waste fitted recently.
Plumber who fitted basin waste discovered a bodge from previous bathroom fitter, where...
Hi Folks, Need your advice on how to access a thermostat cartridge to fix/replace. Please see pics below. I have manged to to get the main shower control cartridge out as it is leaking badly. But now need to sort the thermostat/mixer out now as very stiff and difficult to turn to cold. The...
Hello,
I have a LOGIC a combo Esp1 35 boiler and CM707 control unit.
I want to install Nest - however from looking online the two inputs are 240v from the boiler (cables are thick).
Were it not for the voltage it looks a simple job. How can I do this myself ? Thanks
I need to replace the inflow/outflow pipe to the radiator, dog had a nibble and now has half a dozen small holes in it. I have attached pictures, it appears to be a fexible barrier pipe. I am just unsure about how it all fits together. From the pictures, can anyone tell me if it is a simple push...
Current boiler Worcester Greenstar 30CDi installed Aug 2011. Started showing error EA. Initially a rest made it work again but last Thursday it would reset but then showed the same error after a few minutes. No heating (only problem is heated towel rail does not heat) but also no hot water. Then...
Current setup:
Cold water tank, and header tank in loft.
Hot water tank in airing cupboard at top of stairs.
Power shower (mira event xs) in main bathroom, and same in en-suite.
20 year old Baxi boiler, still going strong.
Background:
Need to free up as much space in loft for conversion. Enough...
I have a copper 22mm gas pipe about 10m long fitted to the outside wall by a Gas engineer using plastic clips with spacers. The clips have become brittle with age and are breaking up. The pipe passes through the brickwork and has no flex in it. Any ideas on how I can replace these clips as the...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.