no hw

Symphony No. 50 in C major, Hoboken I/50, by Joseph Haydn was written partly in 1773 and partly in 1774.Scored for 2 oboes, 2 horns, 2 trumpets, timpani and strings. Since the trumpets double the horns at the same pitch for most of the piece, Antony Hodgson has suggested the trumpets may be omitted. The edition by Helmut Schultz published by Universal Edition under the editorship of H. C. Robbins Landon specifies horns in C-alto with trumpets in parentheses. It is in four movements:

Adagio e maestoso, 44 – Allegro di molto, 34
Andante moderato, 24 in G major
Menuetto e Trio, 34
Presto, 22It is possible that the first two movements of this symphony were reconstructed from a marionette opera by Haydn called Der Gotterath (Prologue to Philemon and Baucis), now lost. The marionette show was performed for the Empress Maria Theresa in 1773.Given that Empress Maria Theresia held rather conservative tastes in music and that this symphony is in some ways less "advanced" than No. 48, scholars such as H. C. Robbins Landon have suggested that No. 50 may be the symphony Haydn wrote for the imperial visit to Eszterháza.

View More On Wikipedia.org
Recent contents Top users
  1. P

    Potterton Kingfisher2 - no CH no HW

    I have the Kingfisher 2 as well and it stopped working last night. Well when i say it stopped what i mean is the pilot light is still on, the thermostat in the hall still kicks it on and off, but the pump makes a loud spinning noise once it kicks in (like there isnt any water going to it)...
  2. K

    therma classic f30e no HW or CH

    Hi guys, I have just been asked about this i dont really know the boiler, anyhoo from what i have been told the boiler is 4 years old been serviced all that stuff now there is no HW or CH the boiler is in the loft with a rad right next to it the boiler fires then goes to over heat, nothing...
  3. J

    ideal isar he 24 no hw or ch

    Got a 3 year old isar he24. display not working (orange pcb) but pump is continuously running and that is all that is working. Any ideas much appreciated
  4. M

    No HW but boiler and pump running fine

    Hi Im new to this so here goes. I have a conventional hw/ch heating system. Im able have HW only CH only or both on at once with a mid port valve. Recently all seemed to be normal but the tank water want getting warm I found the HW thermostat on the floor, looked like someone had knocked it...
  5. P

    heatline c28 no hw ch ok

    heatline c28 flow switch ok took actiuater off pressed pin in while water was running fired up steady flame but no hw return pipe heating up would i suspect the water heat hex being blocked but cust said it was asudden thing rather then agradual
  6. T

    worchester 24i jnr no hw or ch

    today came home flashing light on reset swith around 5 flashes a sec looked in book says possible 5 differnet things it could be pressed boiler reset everything working but the heater kicking in the gas is on and going to the boiler just not coming though the burners and igniting any possible ideas
  7. E

    Please Help Back Boiler has heating but no HW

    Hi All, Can anyone please help me with my dinosaur of a back boiler, before we begin Im a 27 yr old mum of one who tries to do what I can in the DIY stakes, I have no family that live nearby and with little funds Im wondering if anyone can help. I have been away this weekend, came back...
  8. J

    Performa 24i HE problem – no HW & no CH

    Hi all, I’m new to the forum and am looking for answers to a problem that has plagued my Performa 24i HE for the last 3 months. I’ve had a plumber in 3 times; each time he’s replaced a part or adjusted the boiler, but the problem remains. In a nut shell the problem is that occasionally...
    • Jay WH
    • Thread
    • 24i boiler burner central central heating system dhw hot hot water no hw plumber power problem single taps temperature water
    • Replies: 0
    • Forum: Plumbing Jobs | The Job-board
  9. G

    No hw - heatline vizio 24...pcb?

    Hi, Been out to see a lady with a heatline vizio 24. Symptoms: CH is fine, no HW. When i put the appliance into "summer mode/hw only" and run a tap, the pump runs but the fan doesn't. When in "winter mode/ch+hw" the CH operation IS interupted by the dhw demand. However again only the pump...
    • GasMan1983
    • Thread
    • appliance dhw diverter diverter valve flow heatline hot hot water no hw pcb problem pump sensor tap valve water winter
    • Replies: 10
    • Forum: Plumbing Jobs | The Job-board
  10. N

    no HW / CH - Yet

    Hi all, I have a customer who has an indirect unvented system. I would fire up the boiler and loud banging noises would come from around the 3-port and pump area and the boiler would shut down, turns out it was the pump (thanks for that "steve the plumber") Anyway by request of the customer I...
    • nysk2008
    • Thread
    • air banging boiler cylinder flush flushing hose hot hot water indirect job no hw pipe plumber problem pump sludge system unvented water
    • Replies: 3
    • Forum: Plumbing Jobs | The Job-board
  11. G

    Pr1ma 40B - no HW or CH

    Hi all, first post in the forum. I have a Potterton Pr1ma 40B which was working fine, but now I have no heating or hot water. Pilot light is on and the system sounds like something powers up when I engage HW or CH (maybe a pump somewhere else in the house?), but nothing happens :confused...
    • gjsearle74
    • Thread
    • boiler central heating system fix header header tank hot hot water no hw plumber potterton pump system tank valve water
    • Replies: 2
    • Forum: Plumbing Jobs | The Job-board
  12. P

    Halstead Ace No HW/CH after Power-Cut

    Hi all again, Followed the fault procedure for my Halstead Ace boiler and the flow chart said replace PCB - Just done that! made all adjustments but boiler still refused to fire up - any ideas anyone?
    • pacorio
    • Thread
    • ace after air boiler connections control flow green halstead high hot no hw overheat power pressure problem pump reset switch tap
    • Replies: 14
    • Forum: Plumbing Jobs | The Job-board
  13. D

    Potterton Profile 100e CH but no HW

    Please help. The boiler seems to be working fine except that there is no hot water. It has been working faultlessly since last service. Is it the Diverter valve (does it even have one?!) If I set the controller to HW only, the boiler fires up for about 5 seconds then goes off. As stated...
    • dobbie
    • Thread
    • bits boiler central central heating system combi cylinder dhw diverter valve electric hot hot water indirect job no hot water no hw parts potterton profile system valve water
    • Replies: 7
    • Forum: Plumbing Jobs | The Job-board
  14. J

    Worcester Bosch Greenstar 24i no HW

    Hi, I have no hot water yet the CH works fine. The boiler does recognise the demand for HW and the boiler fires for about 20 seconds when the hot tap is turned on before going out. There are no fault lights on! Condenser pipe and flue are clear. Any ideas please.
    • Jonesy
    • Thread
    • 24i boiler bosch combi control diverter valve flow greenstar hammer hot hot water motorised valve no hot water no hw pipe switch system tap valve water worcester worcester bosch
    • Replies: 11
    • Forum: Plumbing Jobs | The Job-board
  15. G

    No HW unless CH is on

    this is a old system with back boiler downstairs and a direct cylinder in bathroo upstairs the only way the customer can get HW is by turning the bathroom rad (1st) off its been like that for years but i said i would try and find somthing out to sort it but i cant think off anything to resolve...
    • garry
    • Thread
    • bathroom boiler circulation cylinder head hot hot water no hw system unless valve water
    • Replies: 1
    • Forum: Plumbing Jobs | The Job-board

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock