Search the forum,

Recent content by ZINXYX

  1. Z

    How do I remove this dishwasher without flooding the kitchen?

    Many thanks. As always very good and helpful folks on this forum. :)
  2. Z

    How do I remove this dishwasher without flooding the kitchen?

    Oh Thanks , read your earlier post again and found the answer for my question about the grey waste pipe.
  3. Z

    How do I remove this dishwasher without flooding the kitchen?

    So in effect after the blue headed valve has been taken off, the hole must be plugged with the 3/4 cap seal. Sorry for being thick. What about the grey waste pipe bit?
  4. Z

    How do I remove this dishwasher without flooding the kitchen?

    Shall I turn the blue headed screw upwards or downwards, please?
  5. Z

    How do I remove this dishwasher without flooding the kitchen?

    Hi, I have had some great advice on this forum which was very helpful. I need to remove a dishwasher without flooding the kitchen. Please can anyone help me? Images atatched Thanks.
  6. Z

    Fitting Ball Valve Issues, please help.

    Thank you everyone. This was finally sorted last night. I used PTFE tape on the olives both for the straight compression coupler and the gate valve. Phew this was one heck of a job for me. At least I can learn from the experience. However I have another issue that is on this thread...
  7. Z

    Fitting Ball Valve Issues, please help.

    Any more advice please?
  8. Z

    Fitting Ball Valve Issues, please help.

    It has a lever.
  9. Z

    Fitting Ball Valve Issues, please help.

    Thanks rpm. sorry i meant to say I was replacing a gate valve with a ball valve. I will need to solder with the straight coupler won't I? Is there an alternative without soldering? Cheers
  10. Z

    Fitting Ball Valve Issues, please help.

    Hi, I am in the process of replacing a 22mm gate vale on the cold water feed to a shower. I had to cut the gate valve off because I just couldn't unscrew it , no matter how hard I tried. In the process of fitting the new ball valve, I have found that the pipe is a few cm short and does not go...
  11. Z

    Gate valve broke.

    Hi, I got fantastic advice from here and sorted out my shower. However it has stopped working again. I have on investigation discovered that the gate valve on the cold water pipe is broken. Will I need a pro or can I do it myself? If I do shall I go for the ball valve? Thank you.
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock