Recent content by std_exceptional

  1. S

    Can I install a water softener after an accumulator?

    Hi, Due to my house layout, I'm trying to figure out various options to install a new hot water system. After much back and forth I think I'm going to go with an unvented cylinder with an accumulator to boost the flow. This is because a vented cylinder (which was my first choice) would result...
  2. S

    Do I need a pump for my vented system?

    I'm not completely against an unvented solution, but even with an accumulator it isn't guaranteed to give me the ability to run two showers at once. It is also more expensive. Maybe a small online lump to just boost the flow slightly will be enough?
  3. S

    Do I need a pump for my vented system?

    Yes, I have had a few plumbers tell me that I should install an unvented system, but with my current combi system, but if two taps are open the flow is greatly reduced, so it is clear the 15mm mains will not support an unvented cylinder without an accumulator, and the cost of that is...
  4. S

    Do I need a pump for my vented system?

    Thanks, the flow rate will be lower at 0.1 bar but 12 litres is the max. I guess I should reconsider having a pump!
  5. S

    Do I need a pump for my vented system?

    Hi all, I'm installing an open vented system for my hot water (bad mains pressure rules out an unvented system) and I'm wondering if I can get away without a pump. I'm going to have 2 bathrooms run off the tank and the showers are rated for 0.1 bar. I figured if i have a 28mm pipe from the tank...

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock