Recent content by piperdave

  1. P

    Shower outlet question!!

    Been to a job today and somebody had decided to use a street elbow and a soldered male iron for a wall outlet instead of using a standard back to wall elbow! There is no way to change this without damaging tiles/plasterboard behind and the property is rented so landlord doesn't really want...
  2. P

    2 x defs in the same room

    hello fellow engineers! wonder if you can help me out ? two decorative effect fires in the same room where should the vent be located?
  3. P

    gloworm 45/60 floorstanding boiler manual?

    Hey does anyone know where i can find a manual for a gloworm 45/60 floorstanding boiler?
  4. P

    Electric shower not getting enough pressure through it to heat the water

    apparently they had the same problem with the shower they changed 6 months ago so definately sounds like a problem with the feed coming into the shower any possible remedys?
  5. P

    Electric shower not getting enough pressure through it to heat the water

    Just spoke to a customer and they are saying they have a problem with there electric shower where they are not getting enough pressure through it to heat the water so its cold all the time , she said its always been a bit funny and they sometimes have to run a tap then turn it off quick to...
  6. P

    baxi solo 2 50 pf problem

    i was fitting a new basin at the property when the customer asked about it he said it cuts out every so often and he turns the dial down then back up again but hes getting fed up with having to keep doing it, there must be a reason why its overheating ? im going to give baxi technical help a...
  7. P

    baxi solo 2 50 pf problem

    i have a customer with a baxi solo 50 pf and the boiler cuts out randomly it was working all ok when i went there but there was a red light on the 'over heat' and red light on the 'boiler on' , has anyone heard of this problem ? any help would be much appreciated !
  8. P

    Gas fire advice turbo toaster mk3

    went there yesterday replaced the solenoid and wahoo! we have a working gas fire :) thankyou for all your replies and especially diamondgas for some excellent advice!
  9. P

    Gas fire advice turbo toaster mk3

    I went back today and have determined that it is the solenoid that needs changing as i tested the lead going to the solenoid. when the fan was on there was power and when switched off and there was no power , so tells me the pcb is fine and sending power to the solenoid when it needs it. i...
  10. P

    Gas fire advice turbo toaster mk3

    ive arranged to go back there tomorrow to have a further look into it :)
  11. P

    Gas fire advice turbo toaster mk3

    like i say the injector seemed clear but how do you suggest cleaning the injector ??
  12. P

    Gas fire advice turbo toaster mk3

    tbh i just pressed it once and the fan came on cant remember what the red light did to be honest definately didnt turn green though , it is a very good point you are making though! , thankyou for your help ill have a look at it ! hopefully someone else will cast there eye over this and back up...
  13. P

    Gas fire advice turbo toaster mk3

    there is an on switch and an off switch next to it when you switch the on switch a red light comes on and you can hear the fan going , unfortunately i left the mi's there and cant find them online so im not sure whether is the same fire were talking about!
  14. P

    Gas fire advice turbo toaster mk3

    you are correct diamond gas i checked the fan and it was working fine :)
  15. P

    Gas fire advice turbo toaster mk3

    there is definately gas going to the fire as there was gas coming out the test nipple when opened, i didnt disconnect the oxy pilot but the oxy pilot seemed to be clear when i blew down it with a tube where the red dot is on the picture below and in the oxy pilot itself
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock