Users can remove all display ads (not sponsors) for a small fee. Click for info (must be logged in)

Recent content by Paul Cockhill

  1. P

    Does anyone recognise this bath shower mixer

    Hi , thanks for your reply. Yes it is 150 centres, so I realise there are plenty of options for new shower/ bath mixers however what I cant work out is the size of the incoming pipe work as the connection looks bigger than a 15mm compression nut. That is why I was trying to identify it
  2. P

    Does anyone recognise this bath shower mixer

    Hello everyone I need to replace this bath/shower mixer but cannot find any identification marks on it . Does anyone recognise it please. I need to replace with something similar Many thanks Paul
  3. P

    Is this drainage pipe needed

    Great many thanks. I really appreciate it
  4. P

    Is this drainage pipe needed

    The smaller wastes connect to the stack pipe below the WC waste pipe, so the WC waste pipe is only used for the WC
  5. P

    Is this drainage pipe needed

    Hi Everyone I have just removed a floor to find out where a WC waste pipe goes. As you will see from the picture, it branches off a long way and is then capped off. I cannot see that it needs this long extension on the right hand side, running along the wall. I presume I could cut it back to...
  6. P

    Simpson shower enclosure help pleas

    Many thanks Ben-gee. I have done the above and tightened them as much possible but still no luck. On some shower enclosures one of the screws will lift it up but not on these. I will try reseating it as you suggest.
  7. P

    Simpson shower enclosure help pleas

    Hi I am trying to fix a sagging door on a Simpson Shower enclosure. The bottom edge of the door hass dropped and it will not allow the door to be closed. The enclosure has an inline panel and return panel . Please see pictures. I thought I might just be able to adjust the hinges but this does...
  8. P

    What external Air admittance valve would you recommend?

    Thanks very much, appreciate the advice
  9. P

    What external Air admittance valve would you recommend?

    hi, Yes I was orginally thinking a cowl but there are windows to the left and right of the stack and the cowl would have to go high over the eaves which would look unsightly
  10. P

    What external Air admittance valve would you recommend?

    Hi I want to fit an external air admittance valve to a new stack pipe, see picture. Does anyone have a particular recommendation. Many thanks Paul
    • Paul Cockhill
    • Thread
    • admittance air america external recommend usa valve
    • Replies: 5
    • Forum: USA
  11. P

    Advice on enclosed cisterns

    Hi Thanks for the suggestion. It is a 6 litre flush but a completely new unit with new pan and cistern. I have not checked the inlet jets or flush pipe but will do Many thanks Paul
  12. P

    Advice on enclosed cisterns

    Thanks Oz, but have made the adjustments and still no difference
  13. P

    Advice on enclosed cisterns

    HI Does anyone have any recommendations for the most powerful enclosed cistern. I have installed a WC unit with a cistern that has a cable flush cistern. It does flush, but might take 2 flushes to get rid of all the waste and often the water only washes down the front of the WC pan , not all...
  14. P

    Hot water issue which has me baffled

    Thanks Chuck, will try that Paul
  15. P

    Hot water issue which has me baffled

    Hi Basher There could be something in this. The kitchen tap is the first mains cold water feed after the stopcock. So could the cold be going up through the tap and pushing it way up the hot pipe, so when the hot tap is turned on it just pushes out the cold water? Perhaps if I put a NRV on the...

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock