Users can remove all display ads (not sponsors) for a small fee. Click for info (must be logged in)

Recent content by Newpark7

  1. N

    Magnetic Filter Location

    Fernox Alphi 11 Antifreeze 5 litres available here Alphi 11 Anti-freeze 5 Ltr | Trade Only Plumbing & Heating Supplies I mixed the antifreeze & Inhibitor together in my Kamco pump & injected in via the filling loop - job done.
  2. N

    Magnetic Filter Location

    Found a solution fitted internally at rear of boiler, sealed system with inhibitors & antifreeze added of course.
  3. N

    Magnetic Filter Location

    To comply with Grants extended warranty form - Yes
  4. N

    Magnetic Filter Location

    Good morning all A quick question where do you install the mag filter on an external boiler installation? I know ideally it should be on the boiler return at its lowest point before the boiler. I am just a bit concerned about freezing etc. As I don't want it installed in the loft either which...
  5. N

    Stanley Range Cooker

    Hi all does anyone have any knowledge of a Stanley Superstar S95? I have a customer who has one and the flue fan has packed up. They want to know is it possible/safe to run the cooker without the fan? I am assuming it is the same type of fan as the one fitted to the Rayburn Flues. I have to...
  6. N

    Underfloor Heating Fault

    Thank you for all who replied. I went back today & stripped the manifold & examined. There is no mixer or blending valve as such on the Rehau manifold, the temperature is controlled via a thermostatic valve Max 50degC at the entry to the manifold. I replaced the pump as many suggested on...
  7. N

    The week ahead

    Sounds like someone I know from Winchester branch lol
  8. N

    Underfloor Heating Fault

    Main pump in boiler or pump on Manifold? Also cannot see a mixing valve on Rehau manifold. Unfortunately I can't upload photos as not enough posts to forum
  9. N

    Underfloor Heating Fault

    Displayed on the boiler -Worcester 30 CDi I did measure on pipe also but paperwork in the van.
  10. N

    Underfloor Heating Fault

    Hi thanks for the reply. In short no other than hearing it run & the fact that the manifold goes cold when it is running.
  11. N

    Underfloor Heating Fault

    Hi All I would appreciate some help/advice on an UFH problem I was called out to this week. The house has UFH via a Rehau 10 way manifold (see attached pictures) on the ground floor & all zones are controlled by Drayton hard wired Progammable room stats to Actuators on the manifold. The...
  12. N

    Boiler options

    Never seen one of them before - Never stop learning :-)
  13. N

    Benefits of Power Flushing

    Builders are the worst - I tell them if they want the scrap they will have cut it out this usually puts them off as they haven't a clue which pipes they can cut and which ones they can't!!!!
  14. N

    Custard nearly had me there!

    Had very same thing today!
  15. N

    That Monday Feeling!!

    Hi Mark yeh you can't beat the old Bungee straps. Needed to run them up to set pump pressure & emissions but you can't get to the adjustment when the panel is on. See picture of how I held the burners.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock