Problem Refilling Ideal Logic 15

Post new thread

Currently reading:
Problem Refilling Ideal Logic 15

Discuss Problem Refilling Ideal Logic 15 in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
D

diegomirabal

Hello, I´ve been having problems with my heating system, I tried to reset it both in the control panel and on the boiler (Ideal Logic 15), but I keep getting the same error code (low water pressure). Right now the pressure gauge is marking 0 psi, I know I need to get the pressure to at least 1 psi, The problem is I can´t find the filling loop, On the bottom of the boiler there is a yellow valve (I think is to cut the gas supply) and on the top I can see three pipes that go into the boiler (including the one with the pressure gauge) but none of them have valves or anything that looks like a flexible pipe. I went into the attic following the pipes (first time because this is a rented house) some of the pipes go to a water tank and then 3 more to a smaller tank on top of the other. Again I couldn't find any valves. Where do you think the filler loop could be located?. As you can tell I don´t know anything about boilers.

Thanks a lot!!
 
Sort by date Sort by votes
it wil lprobably be in he airing cupboard ,silver braided flexible pipe with tap either one end or both if your lucky there will be another guage if no guage put a 5 second squirt in then check the one on the boiler repeat till its at 1/1.5 bar or get some one else to watch the guage to tell you when its high enough
 
Upvote 0 Downvote
sounds like open vent, in that case it fills itself. check water level in small tank. Could be also blockage from the tank in that case it wouldnt fill. Did you try to open bleed valves on radiators to see if there is any water left as might be full of air.
 
Upvote 0 Downvote
If the pipes are attached to the boiler at the bottom it's a system boiler - thus requires pressure if only the gas as condensate are at bottom and two heating pipes at top it's a heat only and can be a said used on an open vent which should self fill. If it rented - get off the forum and get on the phone...... That's what you pay rent for.
 
Upvote 0 Downvote
Thanks a lot for your answers.
I Know this should be cover by the landlord, but I would like to try and fix it myself to learn in case I need to do it again in the future. Also when I went to the attic and check the water tanks, I got a little bit scared, if those tanks are providing the water Im drinking, I got bigger problems than the heating. I've been trying to post pictures so you can have a better look of the system and the state of it but the forum won't allow me. I´ll try to find a way.

Thanks again, you are really helping me here.
 
Upvote 0 Downvote
this is one bloody awful install. follow heating pipes, probably where hot water cylinder is your filling loop, mains connected to one of your heating pipes. however judging from pics this can be a nightmare. I would call landlord first as if something go wrong you will be liable.
 
Upvote 0 Downvote
diegomirabal said:
Thanks a lot for your answers.
I Know this should be cover by the landlord, but I would like to try and fix it myself to learn in case I need to do it again in the future. Also when I went to the attic and check the water tanks, I got a little bit scared, if those tanks are providing the water Im drinking, I got bigger problems than the heating. I've been trying to post pictures so you can have a better look of the system and the state of it but the forum won't allow me. I´ll try to find a way.

Thanks again, you are really helping me here.
Click to expand...


Just remember that this isnt the water you drink and it shouldnt be drunk, this is just for your hot water which also shouldnt be consummed, beautiful pipework right enough
 
Upvote 0 Downvote
Landlord will only bring in another crap plumber, only a crap plumber would work on that, a good one would rip it out
and start again, most on here would just refuse I would think, not seen much worse.
 
Upvote 0 Downvote
BTW there is no filling loop on this job its F&E and how the pipework has not frozen up in winter is a miracle, got to be in the Sunny South. I wonder why, when a tenant moves into a rented house they always want to take over general maintenance especially the heating system. Maybe because the landlord won't...
 
Last edited by a moderator:
Upvote 0 Downvote
do these boilers have a rear flue option, as the picture shows the flue turrett but with no flue and a circ pump sat on the top where flue should be?
 
Upvote 0 Downvote
Last edited by a moderator:
Upvote 0 Downvote
I suspect that many may be landlord- tenants . It's like a Tennant but they own the place. Because we all dislike 90% of ll they pretend to be "poor" Tennant
 
Upvote 0 Downvote
i cant decide with that mess if the f and e tank is still connected of if the system has been sealed strange to add a guage if its still open vent so i would assume it sealed but no sign of an expansion vessel?
 
Upvote 0 Downvote
i cant decide with that mess if the f and e tank is still connected of if the system has been sealed strange to add a guage if its still open vent so i would assume it sealed but no sign of an expansion vessel?
needs to get those tanks sorted your probably brushing your teeth in allsorts of undesirable subtances
 
Upvote 0 Downvote
stevetheplumber said:
i cant decide with that mess if the f and e tank is still connected of if the system has been sealed strange to add a guage if its still open vent so i would assume it sealed but no sign of an expansion vessel?
Click to expand...
My assumption is that its sealed up but they didnt bother to disconect and cap the mains supply to the f and e so have tied up the ballcock.
It is rear flued but probably either because the rear flue is often cheaper or more likely because there was a pre-existing hole at about the right location. That pipework screams demolish this house. Or maybee thats my subconscious spotting the wallpaper.
 
Upvote 0 Downvote
Status
Not open for further replies.

Reply to Problem Refilling Ideal Logic 15 in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

B
  • Question
Ideal logic products of combustion in casing
Replies
6
Views
390
ShaunCorbs
ShaunCorbs
S
  • Question
Fd fault on Ideal Heat 15
Replies
16
Views
746
Sarah80
S
F
  • Question
No Hot water, Fixed and Broken Again Ideal Logic 24
Replies
2
Views
346
Lou
Lou
P
  • Question
Ideal Logic Combi 35 constant F1 fault
Replies
16
Views
1K
exedon2
exedon2
M
  • Question
Help needed on Ideal Logic Heat 15 System Boiler showing F3 error code
Replies
1
Views
1K
Deleted member 120897
D
Back
Top