This is driving me crazy. We moved into this house less than a year ago but only had this issue for about 3 months. Now it's getting into summer it's making it a priority to sort as it's so bloody hot when thr heating is stuck on.
Programmer is on manual mode and even when the hw or ch is...
Replacing bathroom towel radiator, while I‘m at it was going to change the valves for new ones, however this bottom nut is completely stuck…. Any advice for getting it off? Have tried using grips to hold still while using spanner to undo, have tried WD40, it just won’t budge 😬
Hey all, I have a tap handle that wont come off!
In the bathroom, we had a leaking tap, so we decided to replace the washer. We took off the button at the back and unscrewed it too. Now, i know that it is supposed to just pop off but mine didnt. It will still turn round and it slightly looser...
After power cut boiler over heated, since then water is dripping from the over flow pipe. I have a heat genie could it be stuck open or dirt causing a drip? How do I stop it ?
Vinny99m
Thread
could
drip
dripping
flow
genie
heat
heat genie
open
pipe
stuck
I'm a DIYer and I have a Widespread Bathroom sink that i'm working on. The cold water handle is loose and turns on top of the countertop. I've looked under the countertop and can see that the nut that is used to snug the fixture isn't all the way tight. The problem is there is water corrosion...
My bathroom was installed a few years ago and the sink waste has been glued in with silicone. Doesn't seem like just a bit, even the overflow holes are completely blocked with the stuff.
It has become a bit corroded and I have a new one to put in but all the silicone means I can't get the old...
I have a towel rail style radiator in the bathroom with straight through taps.
I have noticed tonight one of the valves has started dripping. I can sort some new valves but the other valve that isn't leaking appears to be stuck open.
How do I best drain the radiator to change the valves given...
I'm hoping to do a magnacleanse clean shortly but the speedfit connectors on the magnaclean micro valves on the system seen stuck on and will not budge.
I would prefer not to drain system and remove compression fittings on the filter but realise I might end up having to.
Im in the know on how...
Hello,
I am a complete novice but am trying to repair a dripping tap using online instructons on replacing the valve. My kitchen mixer tap is dripping. I don't know whether it is the hot or the cold valve as I haven't managed to find a way to turn off just the hot water so have turned off the...
I'm trying to pull a Polypipe SA62B access plug and cap out of the soil vent branch (which I think is a Floplast SP190). It's a bit of a cramped space and it feels VERY stuck. Any suggestions?
I'm removing it so I can fit a pan connector.
Three years ago my contractors installed my new SVP...
hi i have a dripping tap at the kitchen sink but the isolation valve will not move, i have tried wd40 on it but it wont budge.
any advice on what to do with it please?
also i live in a maisonette and there is no stop tap thing under the sink- any ideas where i would / could find the tap to turn...
nick-1973
Thread
america
isolation
kitchen
kitchen sink
sink
stuck
under
usa
valve
Hello. I am here for some advice please.
We have a water underfloor heating system in our house and have recently had some issues with one of the zones seeming to overheat with the heat still being sent despite the thermostat not sending demand or even being on an all. These are all new...
Hi, I would appreciate a little help.
I am unlucky enough to have an 8mm microbore gravity fed indirect central heating system (11 Radiators) on a 30 year old free-standing floor boiler. The radiator valve/lockshield are the twin entry type (8mm).
All the radiators are fine except for two: a...
Hi all,
My push up plug in the bathroom sink is stuck. Please can you let me know if you are able to fix it and how much it will cost? I am in the Purley (near East Croydon) area.
thanks,
Nav
Hi all,
I have a push up plug in my bathroom sink. It is now stuck and I have tried a few options. It really is stuck and I wonder what I should do to get it fixed. Any ideas how much it will cost me to have it fixed, if I am not able to do it myself?
Thanks,
Nav
I need advice about diagnosing why our Triton shower is stuck on max flow, with the flow control dial not responding, please.
It switched on/off ok with no leaks. The filters were clear, but there is a lot of black spot inside the whole unit. Temperature is also good
It's a Triton IPS Thermo...
Hi there,
We have a shower unit which normally has a peg-shaped trap in the waste to prevent large objects going down the waste pipe. However when it gets clogged up with hair etc. my other half tends to just pull it out (and leave it out) so lo and behold, something large has gone down there...
Hi,
For a while now one of my flush buttons on the toilet has started sticking down and so it just continues flushing. I can get it to pop back up by wiggling it around a bit but this is starting to get quite annoying.
Is there any part of the system I could easily replace myself that would fix...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.