bath waste

Currently refurbishing a bathroom and due to limited room between the bathroom floor level and a window below next to the soil stack is it possible to connect the 40mm bath waste in to the top of the horizontal wc soil pipe run before it enters the vertical soil stack???

Hi, I hope someone can help with this problem. Our bath isn't draining away water. First tried a drain unblocker bought at a supermarket down the plug hole, this seemed to make it worse - before it was draining away slowly and now nothing is draining at all. Have had a plumber out today who...

We are just about to complete a modern contemporary bathroom where all taps & fittings are high quality brushed stainless steel but we are struggling to find a bath waste / overflow to match? Has anyone come across this item?

Hi hope you guys can help...... I'm fitting a new bathroom suite and shower, but i have concrete floors. My old shower tray was sitting on an 8 inch deep timber frame, so as to get the height required for the shower water to run downhill ,along under the bath, then into the bath waste...

Had a look at various types by screwfix - none of them get very good feed back. Any ideas .... im open to any system , but ut needs to be robust in operation, its a guest house bathroom. Price whilst not irrelevant is secondary to performance robustness thanks TL

Hi all, I'm hoping that someone can help put me out of my misery here as I've been searching for hours with no luck! Basically, the pop up plug in our bath was trodden on when it was up, and it has snapped the brass bolt that fits the bath plug to the waste pipe below. It's a hollow bolt...

Hi Guys I am installing a new bathroom for a customer and having a problem with the bath waste. It is an exposed chrome outlet and chrome p trap on a free standing bath and when I screw the trap onto the outlet with the fibre washer in place and tighten up I cannot get a watertight seal. I have...

Hi Regarding waste Bath or Sink, have been having major problems with bath waste, can not stop it dripping, driving me mad, does anybody have any tips on what to put into the joint, its dripping from where the waste joins the bath plug hole,have been told to use plumbers mate ect , what is best.

Hi Need some advice on a bath waste. I have just started on a job,it was a wet room,and the customer wants a Bath plumb in. I broke into the existing shower waste in the floor ,but the pipe that goes under the concrete floor and out into the drain is only a 32mm pipe,would this be ok, for a...

I have posted this question before ,but did not get a answer that helped. I am going to plum in a Stand alone bath with no skirt. At the moment the room is being used as a wet room,it has a waste in the floor like a normal wet room.The new bath will be directly above existing waste hole. My...

My bathtub has a waste that looks more or less like this: Every so often, the drainage gets so bad that I unscrew the little filter that is under the plug in that picture, and find a kind of white gunk clogging up that little black cylindrical section. It feels kind of rubbery. I've cleared it...

Hello! I'm hoping you guys can help with this one as its proving to be a real nightmare for me. I'm trying to change the waste pie and overflow on my bath. The bath is about 60 years old, so getting the old system out was difficult to say the least, but I did eventually manage it...

hi guys, quick one i hope. im ready to fit my new bath, but have a issue regarding the waste pipe. the old one goes into the soil stack just infront of the bath, with what looks like pushfit connectors......this is better shown with photo's/ as it used to be with a 90 removed with...

Hi, The fitting instructions for these wastes state that a rubber washer has to be installed between the waste and the inside surface of the bath. When this is done the waste sits slightly higher than the bottom of the bath. This results in a small amount of water being retained around the...

Hi, new on here – and, yes, you guessed, I have a problem: Hole in bath is about 8 mm larger than waste (largest obtainable) that drops into it - i.e. a 4 mm gap all round. So I will not only have the usual sealing difficulties but also have to contend with side-to-side movement. Can anyone...

I've had the Geberit bath waste fitted, but I pulled up on the plug cover and it came off, surely it shouldn't have done that? It has a thread and a bolt on the end. Was it put together incorrectly?:confused: Bath and bath waste has been fitted.

I have a cast iron bath on feet and have not been able to find a waste outlet that is shallow enough to clear the floor. I originally cut a hole in the wooden floor to allow the trap to fit under the waste but have now tiled the floor and do not want to cut into this. I have been to quite a few...

Hi I've just started work on a bathroom. I'm replacing the bath, basin and toilet. After taking up the first floor panel (nice chipboard - which is poorly laid and needs either re-screwing or replacing) I noticed that the bath waste (which is no doubt linked to the sink waste is at a very...