J Jase222 Messages 4 Oct 3, 2022 #1 I need to replace the flow and return in the loft but using a torch is out of the question, is it wrong to do it entirely in compression? As don’t really like pushfit and press fit the cost doesn’t work out ?
I need to replace the flow and return in the loft but using a torch is out of the question, is it wrong to do it entirely in compression? As don’t really like pushfit and press fit the cost doesn’t work out ?
Roy_66 Messages 257 Oct 3, 2022 #2 Go for it. Good choice for your project. Have you done any before? Don't forget your pipe support so pipes not flapping about. Cheers, Roy (Amateur) Upvote 0 Downvote
Go for it. Good choice for your project. Have you done any before? Don't forget your pipe support so pipes not flapping about. Cheers, Roy (Amateur)
gmartine Esteemed Gas Engineer Messages 2,342 Oct 3, 2022 #3 Up to you but Tectite fittings for copper are fine, 'cept they aren't demountable. Upvote 0 Downvote
exedon2 Esteemed Messages 978 Oct 3, 2022 #4 Tectite classic would be my choice(they are demountable), Upvote 0 Downvote