water heater

Hello all,happy new year ! I need to find an electric multipint water heater fed by mains pressure and able to supply a bathroom( including shower), and a kitchen sink. In a soon to be refurbished small first story flat. There seems to be a lot on the market, can anyone suggest a good quality...

Hi The above heater will not heat the water up enough, it was fine up to a few days ago The burners fire up fine on opening the taps and the pressure is sufficiant to allow full operation of the burners but the top pipes of the exchanger are not very hot . I can still hold the hot outlet with...

can anyone recomend an electric water heater similar to the santon r range of open vented water heater .seen the ariston unvented range but the prv pipework would be a pain as its in an internal room

Am i correct in thinking that im not allowed to touch any unvented water heater of over 15litres in size without my unvented card?? I think rules surrounding these heaters are a joke anyway. I think you should need the card for all unvented heaters regardless of size. Still potential for explosion

Hello everybody, I hope this is the right section to post. Two years ago I bought a Rinnai Infinity 11 water heater: I'm so disappointed! I used to have a Beretta (an Italian make, I'm not sure if it's known in the UK) that worked alright for about 10 years. Then, when I wanted to change it...

I'd appreciate any advice on this situation. We have a very old Chaffoteaux Britony II multipoint water heater fitted under the kitchen sink. It is working fine, although recently we have had to replace 2 fibre washers after the inlets leaked. The first was replaced by a local plumber, the...

Brittony water heater problem. Pilot stays light but when hot water opened up does not fire and goes out. Diaphragm faulty???? Or other fault??? Cheers

Brittony water heater problem. Pilot light ok but when hot tap opened the pilot goes out. Can anyone give advice as to what problem might be. Thanks

Hi, I have an ariston unvented hot water boiler std 150. There are two elements attached, one for the night and one for the day. The water does not heat up during the night because i think the thermostat keeps cutting out. I had a plumber round who just reset it for me but it happened again...

Got a call out to this right at end of the day , gas powered water heater hot water supply pressure to taps has dropped off , its a tank fed water heater with open vent and pumped circulation . I can hear the air going through pump and spluttering through pipes to taps .When i run taps on one...

Does anyone know why the Pilot Light keeps extinguishing on a Main Mersey Water Heater?

Hi Guys, I am having a problem with a rointe rd water heater. The hot & cold water connections are made in 1/2" PLASTIC! threads, the problem is I can not find anything to fit them as a rigid fitting. At the moment the only thing that seems to fit is a 1/2" flexi tap connector because the...

Hi, hope someone can help. i have recently fitted an ariston europrisma under sink water instantanouse tank, it was working fine on the few times i tested it over a week. no leaks and nice hot water. i have fitted it in a chalet which is only used a few times a year by the owner. they came...

Hi Friends Can you advise please? Just looked at a job, new sink with monobloc tap with 3 flexi connectors. I need to fit tap to sink (kitchen) then under the sink is a water heater with an inlet/outlet and a feed of cold water from a independent water cooler. My questions are:- For the 3...

Does anyone have any experience of installing Stiebel appliances in the UK? They seem to be pretty standard for hot water in Germany (i heard the word "gas" brings them bad memories) 13.2kW is as high as i can find on single phase... anyone know any different? Alternatively has anyone tried...

Is it possible to use some kind of pressurised tank in conjunction with an instantaneous water heater in order to improve hot water temperature in winter, by raising the cold mains temperature to room temperature? I'm looking at options on hot water for a small flat conversion. Working to small...

Morning need some help please,problem is pilot lights but as hot water is called for there is none.changed thermocouple with new, cleaned pilot,took high limit stat of (did re connect ) still not coming on so running out of ideas. how far should thermocouple sit above flame its as if its not in...

I s it possible to install a tankless water heater on the outlet of a hot water cylinder feeding a thermostatic mixer shower? the tankless heater would need to be thermostatically controlled and capable of operating at low pressure. The advantage would be that the majority of the time the water...