copper

  1. S

    Bungalow replacing CH pipes in concrete (due to leak) with drop down:Hep20 or Copper?

    Hi, I am a relative newbie to the site. Following my last post it seems we've got a leak underfloor with the CH pipes set in the concrete slab of our bungalow. The boiler pressure is dropping from 1.5 bar to zero every 24 hours. As there are no visible sign of leaks anywhere to be seen in and...
  2. E

    push fit fittings on unvented cylinder

    looked at an install today and the pressurised cylinder cupboard ws completed in push fit. The tundish hadnt been conected yet but wht are peoples views on it. i personally only use copper but am told plastic is ok. Eddie
    • eddiebrown424
    • Thread
    • copper cylinder eddie fittings pressure push fit unvented unvented cylinder
    • Replies: 4
    • Forum: Plumbing Jobs | The Job-board
  3. A

    pipe repair problem

    I have 4 22mm pipes (hot cold and two central heating) all running together ( no gap between them). someone has put a nail in the second pipe. i can not separate the pipes to cut and couple. And suggestions?
  4. I

    Ways to prevent slip coupler slipping down a vertical copper pipe while soldering?

    Ideas please?
  5. I

    Installing plumbing fittings so they are removable on unmovable copper pipe

    Is it possible to install compression valves onto existing non-pullable copper pipe WHILE designing-in a means of being able to replace the whole valves should they fail? Hello, I have existing 22mm copper pipe that needs a small section cutout to install a compression isolation valve...
  6. B

    connecting old copper pipes

    i have recently had to fix a leak on a section of old copper pipe. the pipe is slightly bigger than 22mm and is thick enough to have had a thread put on it. any ideas how to replace a section with 22mm copper? there has been mention of a transitional coupling, however this a DHW pipe
  7. Eyespy999

    copper pipe clips what do you recommend for 22mm

    Morning all. I am running some 22mm copper later today, I normally use Talon clips from screw fix, as you can add on spacer blocks for the gap, what other plastic clips do you uses, recommend? I have some munsen rings for an outside run. Thanks in advance!
  8. Chalked

    Plumb Center copper fittings

    Who makes thier end feed range? They are reasonably priced, but one end will be tight and needs thing on and the other side is slack! im going back to yorkshire endex. Rant over :censored:
  9. J

    Press Fit Fittings for Copper and Plastic

    Hi I just purchased a Milwaukee M12HPT Hydraulic Press Tool and was looking for some opinions before buying jaws for it - been struggling to find a huge amount of information on the internet! I really don't want to buy multiple sets of jaws, would prefer to stick to one profile, but there...
  10. jaydebruyne

    2 inch Copper Waste Pipe

    Last year the 2 inch copper pipe had a split in it so I cut it off and replaced it with plastic and joined it back to the 2 inch copper with a universal compression fitting. The last part of the pipe has now split so my options are: Cut the elbow off and extend the plastic to there - but I'll...
  11. R

    valor copper flame

    anyone have any info on this fire with a glass front? its quite old c1986, cant find any info on it. dont have council number as i didnt strip to find. need a tc and not sure if its universal or complete! thanks

Newest Plumbing Threads

Back
Top