110mm

Has anyone seen this fitting before clay to 110mm plastic

It's not every day I deal with 110mm soil pipes, therefore I do not have a selection of different fittings at hand to try what combination fits my needs. I have therefore been trying to locate on- line the actual sizes eg length of push-fit tee, spread of branch, before I can purchase the best...

Good afternoon, please see my attached diagrams One is the current layout And one is where I propose to add another boss to add a shower waste. This horizontal run is below floorboards but I can't get to the TEE or under the tee to add a boss vertically. ( the current Bath is bossed way in...

need to go from 3.5" lead soil pipe to 110mm plastic soil pipe

Hi I’m trying to find something that will connect a geberit 90mm toilet waste pipe into a standard 110mm soil stack. The geberit cistern came with an adaptor that increased the outside diameter of the pipe to 110mm. However this is the same diameter as the soil stack pipe. Is anyone aware of...

Hi can I insert a pan connector Finn's straight into the pipe end of an elbow spigot ? I'd rather use this fitting then an elbow with pipe Many thanks

I am currently plumbing in my shower and wondering whether I will get away with the endcap as seen in picture one, already fitted, or whether I should replace it with the solvent weld type that is seen in picture two? Normally you would avoid compression fittings where they are hard to get to...

Hi everyone Customer wants the downpipe and hopper replaced with soil pipe can i cut downpipe just above ground an use a 68mm to 110mm converter or should I dig down and replace gully with underground sweeping bend and connect to clay with adapter not to sure with building control on this one...

I am currently looking at the possibility of adding a downstairs toilet and basin and the only viable drain is a 68mm rainwater on the outside of the wall where the cloakroom will be. I have combined drains at my property, the 110mm drain is reduced down to 68mm CI and runs as a rainwater to the...

Hi All, I am adding an ensuite to our bedroom. The new 110mm soil pipe run (Grey in diagram) is approx 6m long and enters the building beneath a timber suspended floor. The 90 degree bends are swept. I am assuming it would be a good idea to vent the pipe above the new toilet with an air...

Hi folks. Is it OK for me to run 21.5mm boiler condense pipe into strap boss for 110mm upvc? No smells should come back in I'm assuming? Any suggestions where to buy adapters? Ideally all solvent weld as will be internal of property. Thanks very much

Hi there folks, I have had a hunt on here but I can't find what I'm after. I'm trying to find a grey 160mm strap on boss to take a 110mm pipe but I'm not finding it, does anyone know if such a thing exists? The ones I have seen take 32/40/50mm but not bigger, I'm sure I have seen one online...

Hi, Flowplast,pushfit, soil pipe double socket 92.5 bend. New soil stack for new second floor toilet Looks like I need to make a bigger hole in outside and inside wall so that the sockets go into the hole through the wall to match up with the pipe clip distance on the outside stack.... Am I...

looking for a boiler that is the flue is 110mm away from the back wall anyone any ideas peace out

Hi Guys im just double checking that solvent and push fit 110mm pipe is the same i am glueing everything on this job and the merchant has told me the pipe is the same can you confirm this for me ha

Hi guys. I am after some non return valves to stop water backing up sewer into toilets. Ideally to just wack in the manhole. There are lots online but would like a recommendation before buying. Thanks all

Hi folks - I'm after some help with a shower trap that I need. I've got a 110mm pipe popping up for a shower/wet room and I need a trap that'll fit straight onto the pipe - preferably one with a male spigot. The only one I can find is the multiquick version but can't find any info about the...

Hi folks, I'm new to the forums and looking for a wee bit of advice. Having recently bought a new home I've found a leak under the sink which needs repaired. I have a 40mm PVC waste pipe going from the sink into a 110mm cast iron stack, which is packed with what I think is Plumbers Mate or...

Hi I need some advice please The soil pipe elbow exits to low for a new pan at only 150mm centre height - it should be about 185mm If I cut/saw the soil pipe elbow off will the internal diameter left be sufficiently wide enough to accommodate the flexible pan connector shown? I think it will be...

Hi, I'm installing a bathroom at the front of the house and need to get the main 110mm waste pipe to the back of the house where the main stack is. I've had to drill a large hole in the landing wall in order to get the pipe through to the other side, however directly on the other side of the...