Search the forum,

Will a Vaillant 150 Timeswitch fit and older Ecotec?

Discuss Will a Vaillant 150 Timeswitch fit and older Ecotec? in the Central Heating Forum area at PlumbersForums.net

Z

Zippymark

Gas Engineer
Messages
95
I've got an older Vaillant Ecotec combi with a 130 Timeswitch that's broken, can the newer 150 timeswitch be used on it rather than paying over the odds for a 130? I know you can put the pins in a couple of different positions but can't remember if it fits the older ones or not.

Thanks in advance
 
Fit an external one ?
 

Reply to Will a Vaillant 150 Timeswitch fit and older Ecotec? in the Central Heating Forum area at PlumbersForums.net

Similar plumbing topics

A
copper vs pushfit pipes
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
226
Chuck
C
johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
228
exedon2
exedon2
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
170
SimonG
SimonG
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
251
ShaunCorbs
ShaunCorbs
sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
463
Chuck
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock