Search the forum,

Discuss Why do i have one cold radirator in the USA area at PlumbersForums.net

Messages
1
Had a combi boiler installed, Power flush as well. but I have 1 stone cold radiator, all the rest through the house get piping hot, thermostat have been changed, inlet valve has been changed, water flows through the radiator, if youy try to bleed it it comes straight out. so no air in the system.
But the water is cold, won't get hot at all. Even had the radiator off the wall and blown through...

What else could it be?? Does anyone have any ideas??
 
You get water out of both rad valves?
what size pipe? 15mm or microbore? Was system properly balanced by installer?? Try closing all other rads does that rad warm??
 
Just to add, in case you’re still after advice, do the pipes to it get warm/hot? Did it work before combi install? Have you contacted installer?
 
if the pipes are mico/10mm and come down from above you may have a air lock,
turn off trv and lockshield and then open one into bucket till warm water comes out, then do same at other side, reconnect job done.
 

Reply to Why do i have one cold radirator in the USA area at PlumbersForums.net

Similar plumbing topics

Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
167
Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
207
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
203
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
5
Views
135
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
255
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock