- Messages
- 3
Hi, got a porcalenosa mixer shower that i need to replace the valve on it. Not sure what tool is used on it as it looks unusual. please see photos with details
many thanks
many thanks
- Thread starter Hashtag246
- Start date
- Replies 1
- Views 658
- tool
Discuss what tool to open this? in the Plumbing Tools area at PlumbersForums.net
Not the approved way but....either grab the outer edge real hard with some grips to ensure you don’t slip and mess up the thread. If that’s not possible, stick a flat screw driver in to one of the grooves as vertical as possible and hit it with a hammer to get it moving.
Reply to what tool to open this? in the Plumbing Tools area at PlumbersForums.net
Similar plumbing topics
Hi,
My current hot water system needs to be replaced.
Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off?
An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au.
How reliable is this...
Hi all I'm hoping someone can shine a light on this for me
Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall)
Unfortunately turning this to the closed position only reduces...
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Hi All
I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Hi all
Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
- Started by FozzieBear
- Replies: 3
-
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
- Started by boiler101
- Replies: 3
-
Hole in copper pipe, solder under floor, T coupling & protection- Started by dreikher
- Replies: 0
-
-
-
-
-
-
-
-
-
Sewer pipe problems not sure about it
- Started by sammie81116
- Replies: 3
-
-
-