Search the forum,

Discuss What causes noisy hot water tank filling up? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Messages
27
Just started recently - sound like a 'whirr' when hot water tank fills up after hot taps used for a few minutes or after a shower.

I don't think anything to do with Potterton boiler as the noise happens when the boiler isn't on - for either water or heating.

The noise seems to be from the cold water pipe that is filling up the hot water tank.

Any suggestions?
 
ps - we have recently had a problem - that seems to have now stopped - with water coming out of the overflow pipe - this was for about a week and stopped when we run hot or cold water - and then started again - coincidentally the new 'noise' seems to have started but the dripping overflow has stopped.
 
Do you mean the cold water storage tank - the bigger one that feeds cold water down to the cylinder ?.
Yes, we think that is close to where the noise is coming from - unfortunately, there was a 'loft conversion' some time ago (before us) and they have put panelling up and sealed off access to the tank - debating ways to cut a hole through the plywood
 
Sounds like the ball valve has failed in the cold water tank
 
Sounds like the ball valve has failed in the cold water tank
But the water tank does stop filling... just it is noisy when it does fill.. and the 'noise' only appears to happen when we use the hot taps for a while (or hot and cold) - not when flushing the toilet etc... the dripping overflow pipe has now stopped.
 
toilets could be on mains pressure not tank
 
That said, if you have a BS1212 Part 1 float operated valve, it will often sound like a T.A.R.D.I.S. parking with the handbrake left on, even in normal circumstances. Mine does anyway.
 

Reply to What causes noisy hot water tank filling up? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
1
Views
75
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I have changed the 3 port actuator Honeywell head however this doesn’t seem to have solved the issue, does this mean that the programmer is faulty? Or is...
Replies
8
Views
207
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
301
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
1
Views
89
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
0
Views
53
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock