Search the forum,

Discuss Van Racking Ideas & Pressing Tool Gun in the USA area at PlumbersForums.net

Messages
78
Hi Troops, I hope everyone is enjoying a well deserved Sunday off.

I've just purchased a VW Crafter MWB, my last van was Vauxhall Vivaro. I racked it out with Plywood shelfing purchased from Vanify. It was okay but I really like the look of Botts Smartvan. Never seen anyone have it other than pictures I've seen on social media. It's very expensive though, probably around 3k mark. Does anyone have any experience of it, or other manufacturers that do similar van Racking modules?

Other investment I'm thinking about on this Sunday morning is buying a pressing tool? What brands do you use? Anyone know any good deals? Brands to avoid? Good points & bad points? Just a general idea I guess. I'm just at the very beginning stage.

Everyone that has one that I know, absolutely loves them. I do particularly enjoy soldering, I have a 1st apprentice who I would rather learn how to solder first too which is a negative.

Sunday morning expensive thoughts I guess...
 
I've got Sortimo in my VW Transporter Kombi - not cheap BUT I can find everything and if I need to move shelves up or down I can

When I did research, I needed to make sure my Dewalt boxes fitted on the shelves - and found that not all were deep enough.

Hope this helps
 
Bot are decent and there crash rated (which is important)

You could Go down the route or diy eg ply etc prob save around a k

have a look at novopress aco103 decent bit of kit upto 35mm and doesn’t break the bank too much
 
Novopress runs Milwaukee batter

aco103 m12
Aco 203 m18
 

Reply to Van Racking Ideas & Pressing Tool Gun in the USA area at PlumbersForums.net

Similar plumbing topics

The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
0
Views
117
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
256
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
203
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock