Search the forum,

Unvented Hot Water Storage Revision Guide

Discuss Unvented Hot Water Storage Revision Guide in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
A

Aqua Mechanica

I did my Unvented with BPEC, they provided a revision guide which was extremely useful, unfortunately I lost it and it costs £55 to replace (extortionate!), so does anyoen know of a decent "Unvented Book/Manual/Revision Guide" you can buy?
 
read instructions that come with unvented cylinder,they will tell you same as book
 
Yes Davids right!

£55 for a Plumbing book? Should be £1.50p.
 
Status
Not open for further replies.

Reply to Unvented Hot Water Storage Revision Guide in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

F
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
4
Views
368
Timmy D
T
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
252
ShaunCorbs
ShaunCorbs
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
209
DIwhYdidIstartThis
D
C
How to identify dripping tap.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
308
Timmy D
T
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
168
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock