Search the forum,

Unused UFH port...........

Discuss Unused UFH port........... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

P

plumbbobshan

Gas Engineer
Messages
79
Afternoon Lads and Lasses. I am setting up a 2 circuit UFH system the manifold has 3 ports. Do I blank off the spare ports or do I fit a loop and leave it turned off ? The other ports will be controlled with room stats.
 
Blank off or run something else off it eg summer towel rads
 

Reply to Unused UFH port........... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

A
Emergency Stop Buttons in Boiler Rooms
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
236
oz-plumber
O
B
Unvented hotwater cylinder
Fitted unvented hotwater cylinder building control looking forms signed it off job was in england i am qualified northern ireland send out a form to fill in what do u need to sign off in england as building control said they dont give out forms like they do in northern ireland
Replies
4
Views
186
ShaunCorbs
ShaunCorbs
B
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
216
oz-plumber
O
F
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
4
Views
387
Timmy D
T
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
176
dreikher
dreikher
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock