Search the forum,

Discuss UFH Pipe - Which manufacturer is best - Rehau, Uponor, JG, Polypipe??? in the Water Underfloor Heating Advice area at PlumbersForums.net

Messages
5
Hi,

I'm installing a large 8 zone UFH system into a new concrete floor we're installing at a bungalow. I'm looking at the pipework manufacturers and i can't decide which to go for:

I want to install the best under the screed:

I'm currently looking at for Pipes:
Uponor
Rahau
Polypipe
John Guest
Wunatreade

Any comments on which are the best, would be most helpful

Thanks

Tom
 
Try Maincor, itā€™s in my extension and works really well.

As with most things it is more important to have a good installer than a good product, Iā€™m not joking.

Iā€™ve seen some god awful bathrooms with top quality gear in - loads of problems, leaks etc.
And problem free installs using run of the mill products......
 

Reply to UFH Pipe - Which manufacturer is best - Rehau, Uponor, JG, Polypipe??? in the Water Underfloor Heating Advice area at PlumbersForums.net

Similar plumbing topics

Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
227
Hi, I have an old steel water mains pipe (approx 45mm) that I need to connect to a new pehd water mains (25mm). I can't get at it to create a new thread so what's the best way of connecting the two? Cheers, Peter
Replies
2
Views
186
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
276
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it šŸ˜¬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
253
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
12
Views
311
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock