- Thread starter MOSSEP
- Start date
- Replies 5
- Views 723
- mixer mixer valve ufh valve
Discuss UFH mixer valve indentification in the Plumbing Jobs | The Job-board area at PlumbersForums.net
- Messages
- 34,309
- Solutions
- 2
- Messages
- 14
Might be completely wrong here but enjoy the detective work. Is this the one?
Replacement Isotherm Manifold Mixing Valve
Replacement Isotherm Manifold Mixing Valve
D
Deleted member 82985
- Messages
- 49
Appears to be a old Henco System.
Henco - EN Henco
Unfortunately don't know where you'd be able to pick one up from.
Henco - EN Henco
Unfortunately don't know where you'd be able to pick one up from.
Reply to UFH mixer valve indentification in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Hi,
I have an old steel water mains pipe (approx 45mm) that I need to connect to a new pehd water mains (25mm). I can't get at it to create a new thread so what's the best way of connecting the two?
Cheers,
Peter
Hi,
My current hot water system needs to be replaced.
Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off?
An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au.
How reliable is this...
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
-
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
- Started by boiler101
- Replies: 1
-
Hole in copper pipe, solder under floor, T coupling & protection- Started by dreikher
- Replies: 0
-
-
-
-
-
-
-
-
-
Sewer pipe problems not sure about it- Started by sammie81116
- Replies: 3
-
-
-