- Thread starter Northers
- Start date
- Replies 3
- Views 1K
Discuss Trimming Aqua-Dec Easyfit in the Bathrooms, Showers and Wetrooms area at PlumbersForums.net
- Messages
- 34,309
- Solutions
- 2
Yep you should be fine impey do a guide for trimming / cutting to fit
just need nogs alone the cut edge and new screw holes
just need nogs alone the cut edge and new screw holes
Yes but I think Ill use a saw rather than a grinder!
Many thanks for the replies guys...I’ve also found the Impey technical help site now so I should be good to go.
cheers
Andy
Reply to Trimming Aqua-Dec Easyfit in the Bathrooms, Showers and Wetrooms area at PlumbersForums.net
Similar plumbing topics
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking?
This originally happened about 12 months ago and has happened 3-4 times since.
It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Hello,
I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be?
Thanks
Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
Trying to source a dual-flush valve
- Started by Thomas J Marshall
- Replies: 2
-
-
-
-
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
- Started by FozzieBear
- Replies: 3
-
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
- Started by boiler101
- Replies: 4
-
Hole in copper pipe, solder under floor, T coupling & protection
- Started by dreikher
- Replies: 0
-
-
-
-
-
-
-
-