Search the forum,

Discuss Thermostatic valve replacement in the USA area at PlumbersForums.net

Messages
6
E75F7057-C736-47DA-A4B1-0D428D6FC30B.jpeg
595964A6-CDC7-4F1B-B6C7-11B1C0C159D7.jpeg
Hiya I need to replace my thermostatic valve, can I just buy any replacement valve from local shop or does it have to be a specific one?
 
If you are changing the whole thing then any valve suitable for the pipework size you have. If you want to just change the head you will need the same as you have as the threads are different on other brands.
 
If you are changing the whole thing then any valve suitable for the pipework size you have. If you want to just change the head you will need the same as you have as the threads are different on other brands.
Thanks for your reply
I am just looking to change the head. Any suggestion as to how I can make sure I buy the correct one?
 
It's the thread on the valve and also the height of the pin on your valve. So sorry I don't know.
The Drayton RT212 fits quite a few. Worth a try and most places will have them.
 

Reply to Thermostatic valve replacement in the USA area at PlumbersForums.net

Similar plumbing topics

Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
180
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
164
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
1
Views
95
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
276
I have attached an image of the brass body within a tap. Having replaced a cartridge which has cured a leaking tap, I can see that there is a small leak from the brass body which can be unscrewed. Is there a seal behind the body? Thanks.
Replies
2
Views
291
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock