Search the forum,

Discuss Tap identification in the USA area at PlumbersForums.net

WC1

Esteemed
Plumber
Gas Engineer
Messages
1,253
The numbers on the tap don't seem to bring anything up.
 

Attachments

  • 20210714_105426.jpg
    20210714_105426.jpg
    268.3 KB · Views: 29
  • 20210714_105422.jpg
    20210714_105422.jpg
    253.6 KB · Views: 29
Strewth mate, nobody's ever said that to me before.
No, really I'm UK based but I see what you mean.
I think I'm unlikely to find another and as it's urgent I'll find something similar.
 
Handle is lose and threads stripped so can't be tightened. Have purchased the eBay one. Fingers crossed.
There's several at this place, I'll speak to zip (zenith apparently in NZ) also.
 

Reply to Tap identification in the USA area at PlumbersForums.net

Similar plumbing topics

Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
198
Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
178
I have attached an image of the brass body within a tap. Having replaced a cartridge which has cured a leaking tap, I can see that there is a small leak from the brass body which can be unscrewed. Is there a seal behind the body? Thanks.
Replies
2
Views
230
I have a plumber coming tomorrow to change a cartridge on a badly dripping tap on my bathroom mixer unit. There is no separate isolating valve for this tap so I'll have to close the stopcock. I tried closing it today but it won't go absolutely 100% closed and there is still a very slight flow...
Replies
1
Views
205
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
7
Views
183
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock