Hi, ive recently purchased a Sp140b adaptor for cement pipe to 110mm plastic. When I've looked the vanes end is fine to put into cement pipe but where it has described the other end as push fit I was expecting to see some kind of o ring or seal for 110mm plastic pipe to slot into. Would I be right in returning the item as faulty?
Discuss SP140B vent pipe adaptor fitting in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net
- Messages
- 34,309
- Solutions
- 2
Yes there should be a rubber seal about 10mm from the end is this not there ?
I thought as much no its missing. Cheers
Reply to SP140B vent pipe adaptor fitting in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net
Similar plumbing topics
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it š¬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Hello all,
Iām replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. Iām planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Hi all I'm hoping someone can shine a light on this for me
Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall)
Unfortunately turning this to the closed position only reduces...
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
Trying to source a dual-flush valve
- Started by Thomas J Marshall
- Replies: 2
-
-
-
-
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
- Started by FozzieBear
- Replies: 3
-
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
- Started by boiler101
- Replies: 4
-
Hole in copper pipe, solder under floor, T coupling & protection
- Started by dreikher
- Replies: 0
-
-
-
-
-
-
-
-