Search the forum,

Discuss Soilstack rodding point in the Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Messages
3
I have an internal soilstack with limited accesability.
The soilstack has a rodding point similar to picture below.
I need to attach a 40 mm waste pipe to where the ridding cover is.
My question is ther an adaptor for this job??

Thanks Eddy
pipe.jpg
 
Nope sorry to say will need to cut the rodding point out and install a tee etc
 
Can’t you attach the 40 mm pipe a bit lower using a strap on boss?
There is no room. The rodding boss is at ground level in the back of a cupboard.
I did mastic a 40 mm boss into the rodding cover which has lasted 20 years.
I dont think I have an alternatibe but to do the same so I have just used SIKAFLEX EBT to mastic it in.
I am going to 3d print an extra outer ring to hold the boss in place along with the mastic.

eddy
 
Couldn’t you design a nut that reduces down to 40mm and uses an oring to seal ?
 
Also available in compression if the pipe is 1.5"


 

Reply to Soilstack rodding point in the Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Creating content since 2001. Untold Media.

OFFICIAL SPONSORS

OFFICIAL SPONSORS

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock