Search the forum,

Discuss Shower tray installation: Easiest method of fitting in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Messages
179
Hi guys
Just looking for advice on how to make the installation of a 1200x800 stone resin tray easier.
I'm fitting a tray into a space with three walls, so obviously space is minimum.
The last time I did this I rigged up a pulley from the ceiling joists to raise and lower the tray into position. But setting up the pulley took an age.
What are your methods of dropping the tray in on to its mortar bed?
 

Attachments

  • IMG_20180908_132306404.jpg
    IMG_20180908_132306404.jpg
    144.8 KB · Views: 4
  • IMG_20180909_163217186.jpg
    IMG_20180909_163217186.jpg
    248 KB · Views: 4
  • IMG_20180908_141649365.jpg
    IMG_20180908_141649365.jpg
    255.4 KB · Views: 5
Tricky cos of weight and lack of access...

Stand the tray up on it's open (protected) edge then using say your suction grips + rope lay the tray over on mortar bed and tap tray down to spacer height.
 

Reply to Shower tray installation: Easiest method of fitting in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
0
Views
116
Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
207
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
174
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
179
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
255
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock