Search the forum,

Discuss Shower pump for kitchen tap? in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Messages
5
Can I run a line from my shower pump to my hot water kitchen tap to increase the pressure? If yes, would I call a plumber or electrician?
 
Tricky one to answer

Depends on the pump you have if it’s a dual impella one eg 4 pipes connecting to it then no you can but if there’s any not 2 yes you could
 
This is it.... so I am guessing it would be no?
 

Attachments

  • shower pump.jpg
    shower pump.jpg
    277.9 KB · Views: 7
Why not investigate to understand the reasons behind the lack of pressure first. It could simply be the wrong choice of tap for your hot water system or restricted flow due to failed valve or restricted pipe. There are differences in taps I.e. suitability for high and low pressure which are often not appreciated by those fitting kitchens or taps.
 
Why not investigate to understand the reasons behind the lack of pressure first. It could simply be the wrong choice of tap for your hot water system or restricted flow due to failed valve or restricted pipe. There are differences in taps I.e. suitability for high and low pressure which are often not appreciated by those fitting kitchens or taps.
Thanks Vee. Just purchased the house and have had 2 plumbers out, neither really investigated, they basically told me because it is gravity fed hot water we won't get great pressure and to try a different tap, maybe from Bristan. Very vague suggestions and no real resolution to problem.
 
You could add a single impeller pump to pump all of the hot water if you wish.
Stuart turner monsoon is best.
You would then not need to buy a new tap, so that would mitigate the cost.
Thanks for your reply. Would this Stuart Turner Monsoon replace the Watermill Shower pump we have for the one shower or be in addition to that pump?
 

Reply to Shower pump for kitchen tap? in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net

Similar plumbing topics

I had a plumber fit a new mono block kitchen tap. The water runs very slowly now. Also, not sure if this is to do with it, but my hot water doesn’t get as hot as it did with my old tap. Anyone help?
Replies
7
Views
210
Hi, I'm in my new build 2 years and the shower pump has died. I have an air to water unit downstairs is in the utility which I've been told is unvented and pressurised. The cold water feed into this cylinder is from the attic tank, not the mains as I turned off the mains stopcock to see if hot...
Replies
6
Views
167
We have a gravity fed hot water system in our the house we have just recently moved into. It works fine with the downstairs shower, however we are about to upgrade the upstairs bathroom and are considering installing a shower bath. My concern is that although there is more than sufficient...
Replies
15
Views
663
Looking for any ideas to help. I've a Heatrae Sadia Hot Water tank, heated through Oil fired boiler (working fine). A week ago I reset the air gap as I was having dripping from the pressure relief valve. Since then I've lost a lot of pressure from the hot water feed to my shower. The rest of...
Replies
8
Views
269
    • Like
Hoping someone can please help. I have an intermittent fault with my electric hot water. I have an older style electric hot water service that heats on controlled load over night. The large tank is in roof space of 60s built villa unit. Every few mornings, no hot water will come out of...
Replies
6
Views
415
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock