Search the forum,

reliance tpr15 T&P Relief valve

Discuss reliance tpr15 T&P Relief valve in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
A

ARMIGER

Any one know where I can get one from. It appears this item is discontinued by Reliance - does anyone know what replaces it.
Thanks
 
UK Spares have them.

About £65 plus VAT

Cannot believe they are discontinued as they are used on Santon Prem Plus
unvented. Fitted a new one last month and that had a the RWC tpr15 fitted.
 
I use Advanced Water
(advancedwater.co.uk) - they've usually got most parts for unvented.

Blod
 
Status
Not open for further replies.

Reply to reliance tpr15 T&P Relief valve in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

T
Trying to source a dual-flush valve
Does anyone know where I can get one of these? Toilet is leaking into the bowl. This one pushes in with a half turn but I can't find one anywhere.
Replies
2
Views
185
Thomas J Marshall
T
N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
150
Timmy D
T
B
What is correct toilet supply line
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
179
ShaunCorbs
ShaunCorbs
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
166
dreikher
dreikher
jamespipe
Plumber recommendation for heat pump HWS installation
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
275
oz-plumber
O
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock