Search the forum,

Discuss Plumbing an island sink in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
4
Hi all, I am in the process of planning my single storey extensions plumbing and drainage.
Our kitchen plan has an island with a sink in it and im trying to work out how to get waste in and hot cold supply.
I am having a solid floor construction of 150mm gravel, sand, dpm, concrete. Then in prep for underfloor heating - celotex with a 70mm screed on top.
My thoughts are waste pipe between celotex and concrete maybe a form adding to concrete and sculpted celotex. The same for hot and cold supply potentially ran in another length of pvc pipe to protect them? Waste would be plumbed into new 110mm external drainage. Any advice welcomed as I will be doing all plumbing inclusive of drainage to cut down on cost. Thanks
 
Sounds about right as long as it isn't over a massive distance. (Waste pipe). Could be wrong but 70mm sounds excessive.
 
If it's more than a 3m run then you will need 50mm waste pipe , solvent weld fittings and pipe , hot and cold pipework I would use hep 2o pipe in pipe strapped to the concrete slab under the celotex. Cheers kop
 
If it's more than a 3m run then you will need 50mm waste pipe , solvent weld fittings and pipe , hot and cold pipework I would use hep 2o pipe in pipe strapped to the concrete slab under the celotex. Cheers kop
Thanks Kop, how do you plumb the waste trap as a normal one is horizontal and this will be vertical?
 
Last edited:
Are you making allowances for getting power to the Island as well?
Hi Snowhead, yes I am there will only be a requirement for a pop up socket so will incorporate that as part of the ring main for the sockets, again I was thinking to run this thru plastic conduit again.
 
Status
Not open for further replies.

Reply to Plumbing an island sink in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
5
Views
122
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
5
Views
117
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
105
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
249
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock