Search the forum,

Plastic-coated copper gas pipe???

Discuss Plastic-coated copper gas pipe??? in the Gas Engineers Forum area at PlumbersForums.net

J

Jennie

Gas Engineer
Messages
283
Hi all, I came across some 8mm copper pipe /plastic coated under a gas fire today. I haven't seen this before? Is it OK to be there? (It was put in by a reputable firm local to me, whom I trust, though I'd like to know what it is).
Thanks all,
Jennie
 

Attachments

  • IMG_2190.JPG
    IMG_2190.JPG
    82.4 KB · Views: 19
  • IMG_2198.JPG
    IMG_2198.JPG
    33.5 KB · Views: 19

Reply to Plastic-coated copper gas pipe??? in the Gas Engineers Forum area at PlumbersForums.net

Similar plumbing topics

A
copper vs pushfit pipes
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
212
Chuck
C
dreikher
Hole in copper pipe, solder under floor, T coupling & protection
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
155
dreikher
dreikher
F
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
3
Views
327
Last Plumber
Last Plumber
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it šŸ˜¬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
243
ShaunCorbs
ShaunCorbs
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
189
DIwhYdidIstartThis
D
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock