Search the forum,

Discuss Pipe Detector for concrete floors in the Plumbing Tools area at PlumbersForums.net

Jock Spanners

Plumbers Arms member
Plumber
Gas Engineer
Messages
207
Evening All,
I've just had a mare of a day digging up a kitchen floor trying to re-route pipes. Can anyone recommend some kind of pipe detector that will detect pipes in concrete?
Jock
 
If the existing pipes are part of a working heating system then a thermal camera is probably your best bet, and has the advantage of working with plastic pipes. I'd recommend hiring one to get some experience before deciding whether to buy. Good ones, e.g. FLIR, are quite expensive and unless you do quite a lot of this sort of work and and/or leak-finding you may not break-even on ownership.
 

Reply to Pipe Detector for concrete floors in the Plumbing Tools area at PlumbersForums.net

Similar plumbing topics

Hello all, Iā€™m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. Iā€™m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
202
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
166
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
207
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
216
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it šŸ˜¬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
251
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock