Search the forum,

Discuss Old Honeywell 4200 3879 001 Room Stat Replacement in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
28
Room stat needs replacing as only clicks in above 25

T'is as old as yonder hills.

What could I replace this stat with?!

Thank you!

IMG_20171216_153546.jpg


IMG_20171216_153626.jpg
 
Honeywell 6360b
 
Replaced with 6360B but now the stat overrides the programmer... ie. the boiler does not respond to the programmer, is always on and only goes off when wall stat allows.:eek: Please advise! o_O:)
 
It's exactly the same one as you've replaced so either you've messed with the wiring or you have a very old system

Prog controls boiler and gravity hot water and room stat controls pump
 
seems to have sorted itself now... hmmm. There's gremlins in that there system. Checked wiring.. it may be the programmer needs replacing if it pops up again.
 
Status
Not open for further replies.

Reply to Old Honeywell 4200 3879 001 Room Stat Replacement in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi guys. I'm trying to identify a toilet model before ordering a seat for a customer. I went to what used to be a Roca stockist (they no longer are) and one of the guys there reckoned it might be "The Gap". I went to the new stockist and the guy there disagreed it was "The Gap" and that he'd...
Replies
2
Views
111
  • Sticky
Morning to any Australians lurking around! Register its free, then message me, I'll sort your account out for you. We will need a moderator from each main country too. I'll post this in the Australian forum now.
Replies
0
Views
59
IS IT POSSIBLE TO ADJUST THIS MIXER UNIT? WE HAVE TO HAVE IT TURNED ALMOST FULLY ANTI CLOCKWISE TO GET HOT WATEROUT. THE FRONT PLATE WITH MIRA ON IT PRISES OFF AND INSIDE THERE ARE SOME PLASTIC BITS AND A SMALL CROSS-HEAD SCREW IN THE MIDDLE. THANKS
Replies
6
Views
192
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
199
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock