Search the forum,

Discuss No hot water but radiators working and very hot in the USA area at PlumbersForums.net

Messages
6
Previously had a problem with noisy pipes and the forum suggested replacing the three way valve which has now been done. Before doing that the noise had stopped though the hot water was very hot and turning the boiler thermostat down didn't make much difference. As mentioned the new three way valve is in place now the radiators are very hot and the hot water isn't. Also one radiator at top of stairs remains cold. Boiler is Worcester Bosch less than 5 years old and a new hot water tank was fitted just before lock down. Any ideas??

John
 
its probably still related to your 3 port have you wired it correctly also did you get the right 3 port,

could be airlock if you drained down system. rad at top of stairs either needs bleeding or your TRV is stuck off
 
Turn on heating at controller and turn up room thermostat, turn off water on controller.

If heat only goes to the hot tank - your port and / or wiring are wrong
 
Last edited:
Thanks for that I switched the hot water off (it was left on all the time as it was thought there might be a blockage in one of the pipes) as it was making a bubbling/gurgling noise and the central heating header pipe overflowed and i took out about 3 or 4 litres. Same happened later in the day when the hot water and central heating came on and ran its normal cycle. Although it overflowed as I emptied some of the water from the tank the water level dropped and the ballcock opened and let in some more water????
John
 
Previously had a problem with noisy pipes and the forum suggested replacing the three way valve which has now been done. Before doing that the noise had stopped though the hot water was very hot and turning the boiler thermostat down didn't make much difference. As mentioned the new three way valve is in place now the radiators are very hot and the hot water isn't. Also one radiator at top of stairs remains cold. Boiler is Worcester Bosch less than 5 years old and a new hot water tank was fitted just before lock down. Any ideas??

John
air lock
 

Reply to No hot water but radiators working and very hot in the USA area at PlumbersForums.net

Similar plumbing topics

  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
1
Views
78
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
0
Views
53
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
230
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
301
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock