T
Terry O
Hello
Just had a new pressurised cylinder fitted, the old vented one was operated by a Honeywell RF2 (3 pack) and functioned normally. Having the new cylinder fitted the sensor CS92A had to have the touch sensor changed from the flat type to the push in type. The heat is set for 60c, however it does not stop demanding more heat until I shut it off . I have replaced the sensor for a new one, but the result is the same. The big worry is that The RF2 pack will turn on the water setting to auto after there is a power cut. Which in this case is would be very dangerous
Any ideas wtf is going on ?
Ta for the help
Just had a new pressurised cylinder fitted, the old vented one was operated by a Honeywell RF2 (3 pack) and functioned normally. Having the new cylinder fitted the sensor CS92A had to have the touch sensor changed from the flat type to the push in type. The heat is set for 60c, however it does not stop demanding more heat until I shut it off . I have replaced the sensor for a new one, but the result is the same. The big worry is that The RF2 pack will turn on the water setting to auto after there is a power cut. Which in this case is would be very dangerous
Any ideas wtf is going on ?
Ta for the help