- Thread starter Pete30nz
- Start date
- Replies 1
- Views 795
Discuss New member Pete from NZ in the The Welcome Wagon :) area at PlumbersForums.net
Reply to New member Pete from NZ in the The Welcome Wagon :) area at PlumbersForums.net
Similar plumbing topics
Hello hello,, Hoping there are some experts or experienced Bulgarian plumbing chaps in this site ?. Here in the UK I can fit a bathroom just with the experience I have picked up over a lifetime. I can make copper pipe runs isolaters taps sink shower etc but me and the missus have bought a small...
As recommended by the welcome email, hello all, my name is James Pirie and I am not a plumber but a keen DIY enthusiast mostly due to the severe lack of plumbers available in our area of the North West of Sutherland in Scotland.
I have done some pipework, tap replacements and fixed some leaking...
Welcome again!
I'm 45, a Registered Adult nurse working in busy, acute medical wards. At work, I almost constantly deal with fluids and tiny pipeworks: IV, subcut, veins, ports, midlines, cannulas, oral, and nasogastric.. Yay..
Yet, after Covid19 something started to slowly break down at me...
Hello all, I'm new on the forum, I'm a gas service and repair engineer rather than a plumber. I used to work for a big company, now self employed. I do some install work too but nothing too big as I work alone and to be honest I'm not quick enough at installation work and not experienced in...
Hello. I'm new here, and also a newbie when it comes to plumbing. I hope to learn a lot and also contribute as much as I can.
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
Trying to source a dual-flush valve
- Started by Thomas J Marshall
- Replies: 2
-
-
-
-
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
- Started by FozzieBear
- Replies: 3
-
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
- Started by boiler101
- Replies: 4
-
Hole in copper pipe, solder under floor, T coupling & protection- Started by dreikher
- Replies: 0
-
-
-
-
-
-
-
-