Search the forum,

Discuss New Grohe Kitchen tap in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
J

jmskippy

We bought a new Grohe kitchen tap, it came with flexible connectors but the end which screws onto the valve is too small. The old flexi tap connector was 22mm and the new is smaller, probably 15mm. I have tried to get and adaptor to no avail. The valve end where the connector connects to is just a bit of thread.
If anyone can understand what I am talking about, any advice would be much appreciated.

I have been to B&Q, Wickes, Homebase, Screwfix and Builder Depot.
A guy at Builder Depot was very helpful and gave me something, it's a connector with a 15mm side to fit the new connector and the other side 22mm with a nut and copper washer. He said I would need some copper piping for that and then something on the valve side.

Again, if anyone has experienced this, please help.

Thanks
 
Its a 3/8 connector, take the tap to a plumbers merchant and dont leave without them.

dont waste your time in homebase.
 
Status
Not open for further replies.

Reply to New Grohe Kitchen tap in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Creating content since 2001. Untold Media.

OFFICIAL SPONSORS

OFFICIAL SPONSORS

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock