Search the forum,

Discuss Nearly had another puddle in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
P

Puddle

:)


attachment.php
 
Last edited by a moderator:
Sorry about oversized picture still trying to get used to operation
Called out the other day, no hot water due to faulty immersion heater
went to turn gate valve off to stop water and this is what happened, iron bush fitted to connect cylinder to cold feed, a bit of electrolysis and away you go, luckily I just managed to turn isolation valve off and I have a big thumb, off came my shoe, pulled sock off and wedged in cylinder end with the held of my van key
I just looooove plumbing :D ;)
 
i was in a church about 4 years ago, drain valve on cylinder snapped on me, just like the pic. after sitting for half an hour with my finger in the hole, realised nobody was coming to help. let go for 20 seconds, ran for the mobile, came back stuck me finger back in the hole and rung my boss. me sat with me finger in cylinder in blackpool, rang my boss, turns out he was in wigan his comment "what do you want me to do, drive over and pass you a spanner" before putting the phone down on me.
i sat there for another ten minutes with water slightly passing thru me finger, before i realised i was buggered. let go. run to van. get cloths and buckets and make the best of a bad situation.
vicar returned, house was clean and dry, just asked what the dehumidifier was for?

shaun
 
Hi. As a plumber you would not be trying hard enough is similar had not happen to you. And the customer still thinks you are trying to get more out of the job. Good Luck (good job it was a immersion heater problem hot water really hurts and takes wall paper off a treat.)
 
This is why I spend time (probably too much) reading a lot of these threads, I would not have considered using my sock to plug the whole. I would have been a little lost, probably waited for the search party and grabbed my snorkel.

My phone is never on me and 95% of the time its out of arms reach, I will now remedy this.

I did have a chuckle though, although I would not have had a chuckle if it'd been me. Crying into a pot of flux would have been more like it:eek:
 
Status
Not open for further replies.

Reply to Nearly had another puddle in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

IS IT POSSIBLE TO ADJUST THIS MIXER UNIT? WE HAVE TO HAVE IT TURNED ALMOST FULLY ANTI CLOCKWISE TO GET HOT WATEROUT. THE FRONT PLATE WITH MIRA ON IT PRISES OFF AND INSIDE THERE ARE SOME PLASTIC BITS AND A SMALL CROSS-HEAD SCREW IN THE MIDDLE. THANKS
Replies
6
Views
221
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
216
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock