Search the forum,

Discuss Mains Inlet through loft in the USA area at PlumbersForums.net

JLS

Messages
55
Was asked to look at a Mains inlet today that the property owner wants moving. It currently comes into the hall in black HDPE , through a concrete slab and about 6 inches up the wall in copper, then poly up the wall and through the unheated loft space. It's not pretty, but at least whoever fitted it used 4" insulation in the loft. The owner wants to have a new water pipe laid from the meter into the garage and from there up the wall and into the loft space. Doesn't sound like such a good idea to me but on reflection isn't vastly different to what they currently have. My question is, is that allowable under water/building regs? I know that normally it's 750mm from an outside wall or sealed both ends and insulated if running up the wall but that's assuming it's inside the building by that point. Oh, and it's a bungalow so if they were to go ahead the length of pipe from where it breaks ground to where it drops into the kitchen has got to be 40-50m.
 
I would say it’s fine from the meter underground to the garage stop tap after it comes out of the slab would use some insulation also

then from the stop tap to where the old stop tap is I guess? Would use a coil of speedfit so it’s in one length and use min of 19mm wall insulation will be fine
 
Oh, and it's a bungalow so if they were to go ahead the length of pipe from where it breaks ground to where it drops into the kitchen has got to be 40-50m.
That's quite a distance.

Obviously frost is a problem in winter but I'd also be worried about how warm the water standing in the pipe might get in summer if it's above ground particularly if it's not shaded from direct sunlight. I seem to recall that one should keep potable water supplies below 20°C, but I can't remember where I got the figure from or whether it was a reg or just 'good practice'.
 
That's quite a distance.

Obviously frost is a problem in winter but I'd also be worried about how warm the water standing in the pipe might get in summer if it's above ground particularly if it's not shaded from direct sunlight. I seem to recall that one should keep potable water supplies below 20°C, but I can't remember where I got the figure from or whether it was a reg or just 'good practice'.

Just checked the water regs. It’s 25c.

46618C5F-0756-4FFD-B908-C9A356EBBA83.jpeg
 

Reply to Mains Inlet through loft in the USA area at PlumbersForums.net

Similar plumbing topics

    • Like
Hi I recently did some pipe insulating in my loft. The only two I didn't do were the vent pipes. Not sure if that is the right term for them? They are the pipes that feed water back into the top of the tanks when there is excess, presumably from steam, expansion, etc. The one going to the cold...
Replies
2
Views
333
I need to get a 22mm mains to an unvented tank in my loft. Is an old house and the first part of the roof is pitched and sloping from the inside. The easiest way to get it into the loft is straight up the wall internally and then into the sloping roof the other side of the plaster board. This...
Replies
2
Views
538
Hello, and thanks for taking the time to read. I'm trying to work out if the idea I have is practical? The water pressure in my newly renovated house (4 bathrooms is tragic). Current set up is: A hot/cold mixer in the main ensuite which is ok as long as you don't run anything else. One electric...
Replies
3
Views
368
P
Hi, in order to replace the solenoid on my shower I need to take it off the wall (bad shower design). I've got all the electrics disconnected, it's detached from the wall itself and I've unscrewed where the water pipe from the wall connects to the shower inlet (I'm sorry I don't know the right...
Replies
4
Views
514
Hello. In this recent cold snap my loft has been getting condensation droplets form on the bitumen membrane. I had previously installed lap vents and minimised storage to improve air flow. The loft is well insulated apart form an area under the cold water tank. However my cold water tank is...
Replies
0
Views
1K
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock