Installing a replacement basin/ped?

[macka09]

Hi guys. What's the preferred method of installing hot and colds to a basin on a ped? I know a lot are piped up inside of the ped but with monabloc mixer taps on flexis I'm thinking it may result in the pipes knocking about? Any advice you guys have would be great, thanks.

 

[DuncanM]

Tails out of the wall? If possible.

 

[centralheatking]

Try and keep the flexis straight ..no sharp bends..not for appearance but tight bends do split...always put a ballofix on hot and cold angled so you can operate easily. To be honest
basin and ped set ups are a bit out of fashion. The basin with a cupboard under is way better easier to clean and fit neatly. It can get a bit crowded behind and inside the ped especially with a waste pipe and easily accessable trap ...centralheatking

 

[ShaunCorbs]

on the wall clipped either side (1" off centre line) you could use chrome so it doesnt look too bad if there that was inclined

eg

or you could bring them out 3/4 the way up

eg

not the best images but you get the point