Search the forum,

Discuss How to remove Shower riser rail in the Bathrooms, Showers and Wetrooms area at PlumbersForums.net

jsm

Messages
25
Hi
Trying to remove the riser rail, but cannot see any way to take it off, can't see any grub screws etc... Any help appreciated

Thanks
 

Attachments

  • image.jpg
    image.jpg
    504.2 KB · Views: 16
Yes, it looks like a Mira one. Using a flat bladed screwdriver, or similar, prise in between the tiny gap and push it down (indicated on edited photo), this should hen reveal a screw.
 

Attachments

  • ECAC1A97-9867-4AC6-8129-C9C34C675264.jpeg
    ECAC1A97-9867-4AC6-8129-C9C34C675264.jpeg
    1.2 MB · Views: 10
The grey coloured end bit will be concealing the screws.
It will slide off, either downwards or forwards away from the wall.
Although a sharp tap with a hammer would suffice if necessary.
 

Reply to How to remove Shower riser rail in the Bathrooms, Showers and Wetrooms area at PlumbersForums.net

Similar plumbing topics

The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
175
Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
224
IS IT POSSIBLE TO ADJUST THIS MIXER UNIT? WE HAVE TO HAVE IT TURNED ALMOST FULLY ANTI CLOCKWISE TO GET HOT WATEROUT. THE FRONT PLATE WITH MIRA ON IT PRISES OFF AND INSIDE THERE ARE SOME PLASTIC BITS AND A SMALL CROSS-HEAD SCREW IN THE MIDDLE. THANKS
Replies
6
Views
221
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
304
Hi, basic question, any insight much appreciated. Looking to have an outdoor tap in my front porch fed from 15mm pex coming up from suspended floor. Pic 1 is inside porch, pex temporarily clipped to give an idea of pipe placement (ignore shoddy blockwork of booted cowboy builder!), Pic 2 is...
Replies
6
Views
218
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock