Search the forum,

Discuss Hot water but no central heating from combi boiler? in the Canada area at PlumbersForums.net

Messages
5
Greenstar junior 24i. It's been checked a few months ago.

I haven't actually used it for central heating for a couple of years and seldom for water.

The pressure on it always goes to 0 bars after a few days and usually the filling loop is permanently attached so I would just up the pressure by turning both knobs.

So I couldn't find the filling loop, maybe the council engineer took it by mistake so I decided to use the hose/pipe from the shower.

At first the gauge didn't move so I left the pipe on and knobs open, I came back 10mins later to find water pouring out of the plastic oval shaped thing at the bottom of the boiler system, I then turned one of the knobs and the gauge went up.

So I press the heating button on the control panel for '1hr', which means it should start automatically right away but nothing, I try the same with the water and nothing however when I turn a hot water tap on the boiler fires up and I have hot water etc.

Yet I have no central heating, I have reset the control panel.

In the past I would just press the left hand button on control panel for '1hr' and the central heating would fire up.

Any ideas?
111222 is online now
 
so quoting your opening line why the hell have you got a boiler that you dont use and then want advice on how to fix it when your in social housing. havent used heating for a couple of years and seldom use hot water, what do you expect

Well it's cheaper to run a portable oil radiator. I'm poor. An engineer checks it a couple of times a year so it should be OK.
 

Reply to Hot water but no central heating from combi boiler? in the Canada area at PlumbersForums.net

Similar plumbing topics

Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
212
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
5
Views
225
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I have changed the 3 port actuator Honeywell head however this doesn’t seem to have solved the issue, does this mean that the programmer is faulty? Or is...
Replies
8
Views
197
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
0
Views
53
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
300
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock