Search the forum,

Hello, Another newbie here

Discuss Hello, Another newbie here in the Plumbing Jobs | The Job-board area at PlumbersForums.net

A

Ant

Messages
3
Hello everyone

Just joined after googling some advice and it led me to this forum, which I'll be visiting quite a lot from now on. There's a few little projects I have going on so will be here almost daily I reckon.

Have a good weekend
 
Hello and welcome
 

Reply to Hello, Another newbie here in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

B
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
3
Views
129
Dan
Dan
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
5
Views
125
DIwhYdidIstartThis
D
sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
397
Chuck
C
D
Covering shallow sewer pipe under concrete Patio
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
5
Views
127
DIwhYdidIstartThis
D
D
UK Can't get stopcock 100% closed to allow a tap repair
I have a plumber coming tomorrow to change a cartridge on a badly dripping tap on my bathroom mixer unit. There is no separate isolating valve for this tap so I'll have to close the stopcock. I tried closing it today but it won't go absolutely 100% closed and there is still a very slight flow...
Replies
1
Views
205
Chuck
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock