Search the forum,

Discuss Glowworm Hideaway 80B pilot light will not stay on in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Messages
5
The pilot light will not stay on my Glowworm Hideaway 80B. I have replaced the valve, the thermocouple, ensured all gas pipes are clear of blockages. I have electrics to all plugs. I can't see anything further I can do to solve this issue. Can anyone help?
 
You should not work on your boiler if you are not Gas Safe registered and it really doesn't sound like you are, you're not going to get any advice on this as it would be illegal...
 
Sounds like you need to find a more experienced gas engineer I'm afraid, those that are GSR won't be able to give you any advice on this as it could help you or others (its an open forum after all) do something they shouldn't.
 

Reply to Glowworm Hideaway 80B pilot light will not stay on in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
1
Views
95
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
230
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
90
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
66
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I have changed the 3 port actuator Honeywell head however this doesn’t seem to have solved the issue, does this mean that the programmer is faulty? Or is...
Replies
8
Views
222
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock