Search the forum,

Discuss gas safe inspection event in the Gas Engineers Forum area at PlumbersForums.net

kbs

Messages
3
anyone been on a gas safe registration inspection event?
 
Yes I have, basically a power point presentation session with a small assessment at the end, all based around IGEM/G/11 unsafe situations procedures.
About 25 fairly local engineers for a 3 hour session with lots of questions and answers.
 
I could not make the event as was away, so Gas safe re-organised an actual personal inspection with my usual contact.
Although i know it must have cost a bit more, i much much prefer it as the guy actually sees my installs and gives excellent feedback and help where the installs are a little unusual. (Non dom work).
 
Yes I have, basically a power point presentation session with a small assessment at the end, all based around IGEM/G/11 unsafe situations procedures.
About 25 fairly local engineers for a 3 hour session with lots of questions and answers.
thanks for the reply.. how many questions in the assesment? guessing its just basic stuff that no one would fail
 
Have to agree, I think in person inspections are better and should be carried out. There will be a disaster with this new system and HSE will come crashing down on them. Its a cost cutting exercise which will have bad consequences.
 
thanks for the reply.. how many questions in the assesment? guessing its just basic stuff that no one would fail

Can’t remember how many, maybe 40 or 50, it was open book you were asked to take a copy of unsafe situ. Dead easy pal, we’re told if you failed the test you’d get a site visit.
 
Have to agree, I think in person inspections are better and should be carried out. There will be a disaster with this new system and HSE will come crashing down on them. Its a cost cutting exercise which will have bad consequences.

Haha, that’s a bit extreme! One thing they were pushing is for is engineers to report non gsr installations or even bad gsr installations we come across, I’ve seen plenty jobs not quite right when I go to do a service or landlords check, just bits and bobs like gas pipe slightly undersized or flue brackets missing, I’ll generally just speak to the customer/landlord and give them a price to do the remedial works to bring it up to scratch. GasSafe were encouraging engineers to report the job, I suppose it’s a way of doing site visits without wasting time on decent jobs, but I just guessing there.
 

Reply to gas safe inspection event in the Gas Engineers Forum area at PlumbersForums.net

Similar plumbing topics

We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
3
Views
345
We are from Alberta, and I own an electrical company. I have been asked by a BC Mechanical P. Eng. to install an emergency STOP button at the man-door to the boiler room. It's intent is to 'halt' the operation of the boilers in the room should there be an emergency. He is demanding that I do...
Replies
4
Views
193
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Replies
0
Views
162
Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
207
Does anyone know a good, not super expensive, leak detection company in the London area?
Replies
0
Views
285
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock